Recent Activity
All
Factor E Added a reply to YZ250 squishy front brake
3/30/2021 1:24am Bleed whole system down starting at master cylinder. crack banjo fitting loose allowing fluid to release while holding lever in. Then move to lower fitting do same. now bleed using bleed screw. Zip tie overnight
More »
Factor E Added a reply to 2019.5 450 FE dies off idle
3/12/2021 5:48pm What is idle like-low/high? Ktm-Husky like 1900 to 2000 rpm
Factor E Added a reply to 2015 Honda crf450r issue while rebuilding top end.
2/19/2021 12:14am Google You tube Service manual online
Factor E Added a reply to Ktm 50sx help
2/9/2021 12:29am They do not like heavy foot for starting the gear breaks easy and no return
Factor E Added a reply to 2015 KTM 450SXF center case leak?
2/3/2021 4:16am Sxf- no gasket sealant
Factor E Added a reply to 2020 Rockstar Edition 13hrs won’t start
2/3/2021 3:57am Try un plugging the tip over sensor and plugging back together Recheck plug behind # plate closely-you can unplug and use jumper wire to try and start to see if connector is good
Factor E Added a reply to Moto Van Build - Roof vent the cargo area?
2/2/2021 6:28am A must for fumes Seal the floor seams and walls in case of spills or leaks and will allow you to wash out if needed if using rubber flooring
Factor E Added a reply to 2020 YZ250f top end rebuild question?
1/31/2021 10:56pm Lets see a photo of top of piston and how hard it hit. Rod might not be straight,
Factor E Added a reply to 1979 yz 125 carb issues
1/26/2021 1:26am If you replaced the needle and seat, the new seat should have had a new o ring around it. Could have damaged it on install Maybe float doesn't float and takes in fuel, check off carb
Factor E Added a reply to Engine removal for top end?
1/26/2021 1:16am Use Maxima Clean up or the Air filter clean same stuff in two different cans Soak for a few minutes and scrub with small wire brush Melts off
Factor E Added a reply to What cleaner for brand new bike chain goop?
1/18/2021 5:37am Maxima Clean Up
Factor E Added a reply to 3.2 hours, 2021 KTM 50SX wont start
1/17/2021 9:39am Have heard of petcock being clogged from factory with plastic particals Drain tank and blow out
Factor E Added a reply to 2012 RM-z450 won’t start after cold start
1/17/2021 12:19am If the old wire harness is good put it back on and run it Sound like heat is the issue, poss electrical
Factor E Added a reply to 06 YZ250 revs to the moon when started
1/5/2021 8:15am If it ran fine before you took it apart, go back and inspect everything you touched
Factor E Added a reply to WP Suspension, which route to go?
1/2/2021 4:22am Mark at REP/AEO murrieta CA-former ktm factory guy
Factor E Added a reply to PW50 Issue
12/31/2020 5:05pm Every mini ends up with carb issue due to dirty fuel Must run small inline filter before carb RC motors fuel filter
Factor E Added a reply to Oil on top of piston
12/31/2020 4:44pm Did you stagger ring gaps?
Factor E Added a reply to 2003 RM125 Starting Problems
12/30/2020 7:20am If fuel is running out Does needle have a ring on rubber point and not sealing? O ring on needle seat is bad and allowing the leak, need to replace Oem has kit with both parts
Factor E Added a reply to 2003 RM125 Starting Problems
12/28/2020 3:28pm Pilot circuit still not clean How did you clean carb?
Factor E Added a reply to KTM SX 50 MINI - Restrict
12/28/2020 3:24pm KTM makes a detune/restricted kit for milder power check with dealer