Recent Activity
All
Factor E Added a reply to Graphic - Phil hand injury
9/6/2020 12:14pm Looks like front rotor/fork lug cut it open
More »
Factor E Added a reply to 2005 KTM 250 Front Forks help
9/6/2020 11:57am Check parts microfiche for detailed parts
Factor E Added a reply to 2020 yz250f oil change question
9/5/2020 12:50pm Your manual gives measurements on how much to add that check bolt will strip out if you keep taking it in and out
Factor E Added a reply to 2002 YZ125 carb jet??
8/31/2020 7:38am Thats the Idle screw missing Look at the screw to right of filler tube under intake that should be your air screw
Richard Tease II Liked a reply to forum topic Geico Leaving The Sport?
8/30/2020 5:13pm
This forum topic has 196 replies.
Factor E Added a reply to 2001 YZ 250 troubles
8/29/2020 12:57pm Seized piston probably Float stuck in carb
Factor E Added a reply to 2020 yz250f
8/28/2020 3:43pm Get w Matt at Proven in Ut good w mapping
Factor E Added a reply to Yz450f wifi connection
8/28/2020 10:07am Disconnect ground on battery and reconnect see if that changes anything
Factor E Added a reply to 2019 kx 450 will not start.
8/28/2020 10:04am Sounds like could be ECU disconnect and reconnect
Factor E Added a reply to 2018 YZ250F
8/26/2020 3:33pm Backfire equals timing or electrical
Factor E Added a reply to Orange county (CA) hand orthopedic surgeon Recommendations
8/26/2020 2:47pm Ting is your go to for hand and wrist
Factor E Added a reply to Vhm head on a yz250, is it worth it?
8/26/2020 2:34pm Spend that money on milling head and mild port
Factor E Added a reply to Yz450f whining noise
8/26/2020 2:29pm If it runs past a heat cycle its prob not the top end If it stops running when gets warm, then not good Pull cam bridge and check for no oil marks Have seen cams off by one tooth and bike ran no issue but had whine got louder upon revving. With cams in right time whine went away
Factor E Added a reply to Yz250 4th year issue
8/26/2020 8:10am You have the forks in right order?
Factor E Added a reply to Husky Airbox Lid Holes?
8/25/2020 10:50pm Those are 1 inch holes make it exact to the picture epoxy window screen behind it
Factor E Added a reply to 15 KTM 350 XCF-W, cutting out after 5 min, then backfiring. need help
8/24/2020 11:33am Try running a direct ground from batt to front ground on frame See how long it runs
Factor E Added a reply to Yz450f whining noise
8/24/2020 11:31am Oem crank bearings? A Bearing might not be fully seated in case.
Factor E Added a reply to 15 KTM 350 XCF-W, cutting out after 5 min, then backfiring. need help
8/24/2020 8:42am Prob the stator If the pump was going out sometimes the run time will be shorter overtime you start then go out completely
Factor E Added a reply to Yz450f whining noise
8/23/2020 11:39pm Does it get louder when rev d higher?
RIP Reggie Melton