06 YZ250 revs to the moon when started

dcorbett62
Posts
401
Joined
2/17/2015
Location
Morehead City, NC, USA
Anyone have any idea what this could be? We replaced all the carb jets, air screw, new throttle cable. The carb is cleaned not sure why it would do this? It starts up revs to the moon then shuts off. Any input would be helpful! Thanks!
|
Paw Paw 271
Posts
3632
Joined
4/3/2013
Location
Benton, LA, USA
1/3/2021 2:59pm
YOu could have one of these issues. (You are describing a very lean condition or fuel starvation)
1. Air leak in the intake or at a gasket. ( test with carb cleaner)
2. Plugged pilot jet. ( remove and clean)
3. A lean condition due to plugged inter carb fuel passages. ( remove and do a soak clean of the carb body.)
4. Loose spark plug.
5. Hanging carb slide not fully closing.
6. Incorrect carb cable routing and thus hanging.

Paw Paw
4
sandman768
Posts
8306
Joined
3/21/2014
Location
Saratoga Springs, NY, USA
1/3/2021 3:20pm
My 2008 developed a serious lean condition, revving out like you state.... I could not find the air leak... my friend eventually found it... behind the stator the case was cracked around the entire main bearing pocket! I had it welded by a very good welder, then sold it👍
kb228
Posts
6153
Joined
1/31/2018
Location
Mansfield, OH, USA
1/3/2021 4:30pm
air leak in the crank seal or boot from carb to cylinder. Spray soapy water on it and see if the rpm changes
dcorbett62
Posts
401
Joined
2/17/2015
Location
Morehead City, NC, USA
1/5/2021 3:27am
I’ll try and check it out. Weird because when I bought it it ran fine until after I tore it all apart to clean it all up.

The Shop

Factor E
Posts
988
Joined
9/22/2011
Location
So Cal, CA, USA
1/5/2021 8:15am
If it ran fine before you took it apart, go back and inspect everything you touched
Chaser503
Posts
93
Joined
10/6/2016
Location
Pleasant Grove, UT, USA
1/5/2021 5:42pm
Had this issue on a 2006 yz250 once. After checking and ruling out main seals, dug into carb. Pulled it all apart, cleaned all passages and jets and still had issue after reinstall. Turned out the throttle cable was adjusted such that the slide didn't fully close. Easy to see slide movement of you pull the air boot.

Post a reply to: 06 YZ250 revs to the moon when started

The Latest