Added reply in a thread If you could be any rider in history... 6/22/2022 8:34 PM

Jim Holley. I wasn’t born until the late 80’s but they sound like such an exciting time to be alive. He sounds like he took full advantage of it.

Added reply in a thread Dungey!! 5/28/2022 10:55 PM

RV has the title of greatest retired rider. He may be the 2nd greatest if Dungey keeps this up!

Added reply in a thread Sorry not sorry dc 5/28/2022 1:49 PM

I thought I was paying a subscription for a FULL moto. Not bits and pieces. I still sent them an email to express my dissatisfaction.

Added reply in a thread Sorry not sorry dc 5/28/2022 1:49 PM

I thought I was paying a subscription for a FULL moto. Not bits and pieces. I still sent them an email to express my dissatisfaction.

Added reply in a thread What do you currently ride? Pros/cons? 5/11/2022 5:52 AM

The motor is stock except for a piston and rad valve. Last year I had the countershaft bearing beak apart though and break the case (chain was too tight). As of last year, Honda still had left cases in stock so that was a nice surprise. I was really ... more »

Added reply in a thread What do you currently ride? Pros/cons? 5/9/2022 12:02 PM

2007 cr250. Had it since it was new. It’s had many different looks and many different parts on it, but I’m pretty happy with its current setup. Pros: handles awesome, light weight, sounds and smells good. Decent power. Cons: harder to find parts sometimes

... more »
Added reply in a thread 2003 CR250R brakes compared to new bikes 4/25/2022 8:28 PM

You can try an oversized front rotor, stainless braided lines and fresh rebuilds on your masters and calipers to get you closer. I did that on my 07 cr250 and added ebc mxs pads. It’s pretty close to my buddies 2020 crf450r brakes now as far as power. ... more »

Added reply in a thread Buying one case half? 4/21/2022 7:28 PM

Not sure if Yamaha does it, but I replaced a left case on my cr250 last year and it came with new bearings already in it. Saved me a little money since I only had to order bearings for 1 side.

Added reply in a thread How many of you guys still run one of these? 4/7/2022 6:27 AM

I’ve always worn some type of chest pro. In 2001, the guy in 2nd place got crossed up in front of me and I ended up landing on him. One of our bikes hit me so hard in the chest, it broke the front plate in half and knocked the air out of me. I imagine ... more »

Added reply in a thread Front brake loses pressure 3/8/2022 8:52 PM

Similar thing happened to my Honda. Ended up replacing brake line with a ss line, replacing front disc, rebuilding master then bleeding with a mighty vac for what seemed like hours. The problem was still there. I decided to rebuild my caliper. I noticed ... more »

Added reply in a thread Mugen Honda E-REX 1/14/2022 12:57 PM

If they can figure out a way to make it sound like a tie fighter, I’m in.

Added reply in a thread Post your Pit Bike pics no matter is it's chineese or built up Japaneese. I am ok with that. 10/18/2021 5:48 AM

My 2001 ttr 125. Mostly stock with some bbr pieces.

Added reply in a thread Mixing clutch component brands 10/10/2021 7:04 AM

The kit I was looking at was fibers only. I’ll probably stop trying to be a cheap ass and just get the whole Hinson setup with fibers, plates and springs.

Started new thread Mixing clutch component brands 10/9/2021 9:51 PM

I have a tusk competition heavy duty clutch in my cr250 and it’s been getting the trans oil very dirty after only a couple hours. The steel plates still look perfectly fine but I can tell the fibers don’t have much time left. I didn’t have high expectations ... more »

This forum thread has 4 replies

Added reply in a thread What’s your Race time / Pin it motivation song ? 7/28/2021 10:36 PM

https://youtu.be/5ItHNdrPEh0

Added reply in a thread Mad Skills MX 2 - Daily Dash - Out Now! 5/25/2021 11:32 PM

The game is fun but if there isn’t going to be an option to permanently remove adds, I’ll end up deleting it pretty quick. I’ve been playing mad skills 2 since 2015 and still love the game. I’ve made tons of in app purchases throughout the years, but ... more »

Added reply in a thread YZ250 squishy front brake 3/30/2021 7:16 PM

I had a squishy front on my 07 cr250. Ended up rebuilding the master and caliper and that fixed it. it wouldn’t bleed correctly no matter what I did before I rebuilt them.

Started new thread Replacing cases on 2007 cr250r 2/23/2021 9:28 PM

Well, after almost 14 years of solid reliability, my 2007 cr finally had a major failure. My countershaft bearing came apart and cracked the case pretty bad last weekend at E-street. I plan on replacing the left side case and whole rotating assembly

... more »

This forum thread has 3 replies

Added reply in a thread New Gear Bag Recommendations 6/18/2020 8:09 PM

I like my Ogio prospect gear bag. It's a carry only bag with a strap and some handles. They are $100 pretty much everywhere. It's big enough to hold 3 sets of gear nicely and has a compartment just for boots.

Added reply in a thread Dry, slippery track, short lap times, no fans... 5/31/2020 9:08 PM

I liked it more than watching no racing at all.