Recent Activity
All
ktm-5 Started a new thread 250sxf dies in corner
6/18/2022 2:22pm I have a 2016 250sxf and just did a complete rebuild from the crank on up and the tps is set correct. I bought the bike new last year and had no problems but now after the rebuild my son had it die on him twice right in the corners. It starts right back up with no problem and had...
This forum thread has 29 replies.
ktm-5 Started a new thread 16 ktm 250f kinked gas line fix??
12/30/2020 2:04pm Decided to change the in tank fuel filters and found out my fuel line is kinked. So what is the fix for this?
Weird thing is bike seemed to run fine
Weird thing is bike seemed to run fine
This forum thread has 60 replies.
brody Liked a reply to forum topic holeshot device
2/12/2019 5:22pm
This forum topic has 2 replies.
ktm-5 Added a reply to holeshot device
2/12/2019 4:39pm Just remove them
ktm-5 Added a reply to Rm125 help
2/12/2019 4:29pm I never torque them just tighten them and the spring pressure helps also
ktm-5 Added a reply to best engine mods for 2018 TC125?
2/8/2019 9:00pm Also for best performance don't run anymore octane then u have to. If you use too high of octane you'll lose power too
Bruce372 Liked a reply to forum topic best engine mods for 2018 TC125?
2/8/2019 8:55pm Hey Dan, many thanks for that write up! We are on the fatty with shorty and the V4 on our 2018 tc125 and a few holes in the airbox. On vp T2 ready mixed oxy fuel at 40.1 we went leaner on the pilot and least on the needle... northern cali summers. On the main, I actually went up one size I think. The bike runs amazingly crisp and clean, I've rode it and my only complaint is that it looses a little overrev compared to other bikes (rm144 with mega top end porting). I've heard similar reports about the...
This forum topic has 30 replies.
kb228 Liked a reply to forum topic 2017 Ktm 150, 120 hours
2/8/2019 5:39pm
This forum topic has 7 replies.
ktm-5 Added a reply to 14-up YZ250F Twin Air Power Flo vs No Toil Super-Flo
2/5/2019 4:15pm Performance wise not worth it. I know some bikes had a slight sealing issue and then these were recommended
ktm-5 Added a reply to How to lose 10lbs on a kx/rmz/crf/yz 450?
2/5/2019 4:13pm To drop the weight of a jap bike it would be cheaper to just buy ktm lol
ktm-5 Added a reply to A lot of oil left over in 2 stroke cylinder? HELP
2/4/2019 9:00pm Yup way too much oil for jetting
Blackjack31 Liked a reply to forum topic A lot of oil left over in 2 stroke cylinder? HELP
2/4/2019 9:00pm UPDATE: It is the crank seal. At least that’s what I’m going with because everything else is fine. Runs great so I don’t think it’s a betting issue. The good news is I was under the impression that I had to split the cases, but I don’t.
This forum topic has 14 replies.
PsyCo Liked a reply to forum topic OEM KTM Piston questions
2/4/2019 2:10pm
This forum topic has 8 replies.
ktm-5 Added a reply to 18+ KTM 450sxf Weak/troublesome areas?
2/3/2019 6:50pm Injury has stopped us from having any more time on the bike
4csHATER Liked a reply to forum topic 18+ KTM 450sxf Weak/troublesome areas?
2/3/2019 6:50pm
This forum topic has 20 replies.
sandman768 Liked a reply to forum topic 18+ KTM 450sxf Weak/troublesome areas?
2/3/2019 6:49pm My FE came with spare in line fuel filters, buy a Honda rear brake spring the ktm springs break often.
This forum topic has 20 replies.
ktm-5 Added a reply to 18+ KTM 450sxf Weak/troublesome areas?
2/3/2019 6:26pm You will love this néw bike, even more so than your 350. I was super impressed myself, the way they turn is amazing my son like his 450 stock better than his 16 250f that was setup for him
ktm-5 Added a reply to 18+ KTM 450sxf Weak/troublesome areas?
2/3/2019 6:21pm Nothing any more than any bike. Idk if you've rode the 19 frames or not but it is much better than the 16-18 years
ktm-5 Added a reply to 18+ KTM 450sxf Weak/troublesome areas?
2/3/2019 5:41pm Parts as in motor wear out or chassis/tire ect. wear?
ktm-5 Added a reply to A lot of oil left over in 2 stroke cylinder? HELP
2/3/2019 5:23pm I find it hard pressed to not be a crank seal to get that much oil and I'm sure it won't look like either oil being they are mixing together in the crank case and I've seen studs just as rusty and have no issues. I do clean them up when I tear it apart and if you'd like to...