Recent Activity
All
Factor E Added a reply to 2024 KX 450f oil leak help
6/16/2024 6:02pm That's the weep hole for water pump bearing and seal
More »
lumpy790 Liked a reply to forum topic 2024 KX 450f oil leak help
6/16/2024 6:01pm
Take it back to the dealer they should be able to cover it under warranty.
This forum topic has 8 replies.
Factor E Added a reply to Shift drum binding
6/16/2024 5:58pm Make sure you tighten to proper torque it doesn't like it when over tightened use loctite
Factor E Added a reply to Swing arm bearing issues
6/15/2024 4:53pm Have seen them mispackaged
YZ125H1 Liked a reply to forum topic Pipe rubbing sub frame
6/15/2024 4:50pm
Thanks, I used the other rubber grommet from the exhaust and put it between the pipe now its perfect.
This forum topic has 4 replies.
Factor E Added a reply to Swing arm bearing issues
6/15/2024 9:48am ALL BALLS??
Factor E Added a reply to Honda crf450 touchy front brake
6/14/2024 6:38pm try aftermarket lever that is adjustable
desertratlife Liked a reply to forum topic GasGas won’t run after it gets hot
6/12/2024 5:36pm
My checklist when this sort of thing happens on an Austrian is: 1. Check battery terminals and ground and other electrical connectors 2. Check you spark plug cap and make sure it isn't cracked 3. Fuel filters/pump, Buy a fuel pressure gauge to make this a lot easier
This forum topic has 4 replies.
Factor E Added a reply to ASV clutch perch Help!
6/12/2024 5:33pm CALL ASV AND ASK FOR LUCAS
Factor E Added a reply to Kx250f head
6/11/2024 5:48pm is the groove on the bridge?
Factor E Added a reply to Pipe rubbing sub frame
6/11/2024 5:46pm Use a spacer in front of mount to hold pipe more inward from sub frame
Factor E Added a reply to Four stroke lower rod bearing failure.
6/10/2024 10:06pm There was once a recall for both pairs from factory
Factor E Added a reply to Stock ecu vs vortex ecu starting
6/9/2024 9:47pm Have you tried using another numbered map on vortex? Try turning low trim 2 numbers higher for more fuel
Factor E Added a reply to Stock ecu vs vortex ecu starting
6/8/2024 4:16pm TPS procedure for the vortex been done? how many hrs? dirty injector?
Rickyisms Liked a reply to forum topic My first KTM --- what is the deal with all the corrosion on the fasteners?! --- Best replacement kit?
6/7/2024 7:37am
Specbolt Nickel Wurks come in Engine bolt kits and plastic fastener kits. I think Nickel plating is outlawed in Austria. When I lived close to the beach my raw pipe and stock KTM fasteners went through hell.
This forum topic has 17 replies.
Factor E Added a reply to Crf250r shifter won’t move
6/6/2024 7:08pm Pull clutch basket out complete and look at shift arm to see why its not turning shift drum You might have to pull complete side cover to remove shift arm to turn drum by hand so as to go thru the gears
Factor E Added a reply to 2023 KTM Wiring Harness Failure
6/4/2024 2:49am AssangeMX there has been a problem w spark plug boots shorting out on the new models Using the 22 and earlier boot is the choice
Factor E Added a reply to 2020 YZ250F - pulling head to do a top end question...
6/1/2024 11:43pm You can leave it in
Factor E Added a reply to Leak down tester / testing
5/30/2024 12:18am MOTION PRO
Factor E Added a reply to KTM/Husky clutch slave
5/30/2024 12:13am IF YOU HAVE A SHORT BOLT LIKE THE OTHER TWO TO TAKE THE PLACE OF THE LONG ONE AS TO BOLT IT DOWN THEN PUT LONG ONE IN AFTER SLAVE IS SEATED