All

Isn't that a 2-piece design head?

I’ve got a 25 300sx and I wouldn’t trade it for anything. I had a 16 yz250 with lots of bolt ons and suspension but my 300 is so much better. Less vibration is the biggest piece for me, but the linear power delivery, electric start, and lack of tuning the carb are all amazing. The KTM is much better for me than my built up Yamaha was.

Sure my 25 300sx doesn’t rev out like any of my 350sxfs did. But with a pipe and silencer it revs out just as good as any 250 2t I’ve ridden. It just feels more linear since it has so much midrange power. Exactly where the power is most usable. This is only with the new 23+ engines, I was never a fan of the older tpi engine. And the old KTM 2t SX engines were rockets but not as usable. You would have to seriously build, and run radical fuel to get a YZ anywhere near as usable. I...

I bought a 24 and did the following. Two Stroke Performance mods.Bills pipe and silencer. ECU remap, hi compression head insert. It ran exactly how Steve said it would!! Leaner (cleaned up) bottom end and they richen up the lean mid-top. The bike comes on stronger off the bottom and revs way further than stock. Overall the power is broader making it easier to ride. It’s definitely not as explosive off the bottom as a carbureted 250.. It is definitely a better option in my opinion if you’re a heavier person north of maybe 190 pounds.. The torque definitely helps...

I found that FXR fits me well. I'm 5'10 230lbs. I have to buy a 2XL jersey as I have larger chest/shoulders/back, so the sleeves I typically have to roll up. Pants I wear a 36 and I could almost go to a 34 if I stopped the Oktoberfest beers.😂

So you guys understand the difference between a market cap loss and and an actual out of pocket loss right?

Hey guys, we need to add our 2 cents in this topic. First of all, I would like to explain that running a graphics company is not easy and certainly not cheap. Yes, technologies and materials are very accessible nowdays. However, if you want to provide first-class service, you must pay first-class employees, just like many other businesses. As you know, that's expensive... We try to bring all the options to the table for customers. That's why we offer the so-called Trim Plastic sets, where there are only a few stickers on the plastic, which will add at least a...

pinky, ring, middle

408cc factory Rotax.....

Leatt 9.5 Carbon.

Praying for Scrub Daddy!!