2004 KX 125 Pro Circuit Factory Replica 1

This 2004 KX 125 is a fully Restored Pro Circuit Replica.

This was a fun bike to build and has taken a lot of patience and time. I wanted to do it right and not miss anything. This bike certainly belongs to a collector and or avid motocross enthusiast. It has 2 test rides on it and was recently featured on Whiskey Throttle Media Spotlight and test rode by David Pingree. check it out here. https://www.youtube.com/watch?v=pYpwZ4fydRQ

Engine has been completely gone through top to bottom. Once the bottom end checked out, I sent the cylinder to Millennium Technologies to have them re nikasil/ port and polish just so it was crisp. We then paired it with a Wisco piston and kept the stock bore for reliability. I also fabricated and welded mounting brackets to the frame for a custom water pump guard that was in line with what PC did at the time.

Some of the work that has been done is listed below.

-Custom Phathead racing head. black
-Billitron 38 lectron carb w Custom OEM cable
-Polished PC pipe and Bills Carbon silencer with stinger end cap (Crispy)
-Cerakoted engine cases/water pump and power valve covers
-Cerakoted Break hangers/master cylinders/calipers
-Master cylinder sight glass weld delete
-Master cylinder and calipers fully rebuilt
-Red banjo bolts/ Red caps
-Haan hubs/ Excel wheel set by Dubya
-Light Speed carbon ignition cover, rotor cover F&R, case saver, caliper cover, skid plate, chain guide.
-Suspension internals done by Fenix Suspension-Chris Blose
-Anodized PC brown forks
-Anodized PC brown and hand polished shock body with blue spring. 175 LBS
-Renthal 90s retro purple Twin Wall bars W soft grips
-Arc levers W new cable
-Authentic PC triple clamps reconditioned and anodized PC brown.
-Custom PC logo graphics for triple clamps
-Custom AMA inspection Tech stickers
-Custom graphics kit with gold foil with metallic sparkle laminate.
-Black Polysport plastic kit with flow green number plate and F fender
-Gold heat shield under tank
-PC external coolant reservoir
-PC fuel tank vent tube
-PC red rear break clevis
-TI stem nut and new bearings.
-Factory replica wheel block and TI nut
-Hinson clutch cover
-Hydro blasted linkage with new bearings
-Coated Metallic silver frame and sub frame
-New OEM kick starter
-Factory replica PC seat cover
-All new nuts and bolts in combination with some TI bolts in the right places.

I can also assist with shipping in an OEM crate to destination for an extra cost as I own a shipping company. Thanks for looking!