Recent Activity

All

Madmack Added a reply to 2005 Yz125 tuning

6/2/2021 9:21am
I have the idle adjusted. How much oil is considered too much coming out of the exhaust? I rode around for not even 2 minutes got up to 3rd and stopped. I have a Richer gas mixture than 32:1 because It’s being broken in

Madmack Started a new thread 2005 Yz125 tuning

6/1/2021 11:11am
Bike has a fresh engine rebuild top and bottom end. New carburetor. My old one had a 37.5 idle jet. Bike has a dnd fatty and gytr silencer. Ok so I have never tuned a bike before and I want to learn. The bike idles and for a little then it will die on its own and if I try...
This forum thread has 5 replies.

Madmack Started a new thread 2005 yz125 fire

4/9/2021 4:57pm
Soooo my bike caught on fire on Super Bowl Sunday from a gas leak. I got the fire out in about a minute and a half I think. Mainly just the engine area burned. So far i took off the plastics have this list that needs to be replaced: Cdi wires Throttle cable Clutch cable plastics Gas tank Oil cap...
This forum thread has 28 replies.

Madmack Added a reply to 2005 yz125 fire

4/9/2021 4:55pm
Swapped carbs and it still does it. I don’t think it’s the stator since that side didn’t take too much heat I’m guessing there aren’t any burn marks on that side will post pics.

Madmack Added a reply to 2005 yz125 fire

4/9/2021 4:43pm
Update: throttle was getting stuck at carb shaved sleeved and fixed that. took apart the carb and cleaned. Bike starts and runs and I can cruise but when I try to hit powerband the bike tends to bog I would say. I thinks a seal went bad from the heat Im going to have the bottom end rebuilt

Madmack Started a new thread Jd jetting carb yz125

3/24/2021 2:31pm
I have a 2005 yz125 and need a new carb and was thinking of a jd KEIHIN carb part #JDKH38. Anybody have experience w/ these? How does it help the bike w/ performance?
This forum thread has 2 replies.

Madmack Added a reply to 2005 yz125 fire

3/20/2021 7:41am
Do any of you guys think my engine is fine? It was on fire around the engine for about 2 or minutes

Madmack Added a reply to 2005 yz125 fire

2/23/2021 5:26pm
Do you know where I could get some graphics for the rtech kit? I’m having trouble finding some decent ones if I decide to go that route

Madmack Added a reply to 2005 yz125 fire

2/19/2021 1:10pm
I went on Motosport and looked up the schematics I have basically everything I need in the cart except for the airboot

FGR01 Liked a reply to forum topic 2005 yz125 fire

2/19/2021 1:09pm
Your tank might still be fine/usable. Likely what happened is when the bike laid over gas came out the overflow tubes on the carb and caught fire from footpeg sparks. The tank should be good unless the subsequent fire melted it. Take the tank off the bike, clean it up good, fill it with gas and check for leaks. Make sure you replace the carb vent hoses and route them correctly (up and over from each side). The bike will not run correctly with missing hoses or hoses that are too short or routed incorrectly.
This forum topic has 28 replies.

Madmack Added a reply to 2005 yz125 fire

2/19/2021 1:07pm
It doesn’t mention an adapter in the info for the link you sent but it does have an air box conversion.. who sells good graphics kit for those?

Madmack Added a reply to 2005 yz125 fire

2/16/2021 3:38pm
I will check them out but I have to change my gas tank anyway that was the reason this started unless the bike just caught fire from me falling

Madmack Added a reply to 2005 yz125 fire

2/16/2021 3:37pm
I didn’t really check the air boot I will check that eventually but I remember seeing before that the number plate is different where it screws in it or the front fender but I think it’s just a very slight difference in the plastics

Madmack Added a reply to 2005 yz125 fire

2/16/2021 3:34pm
Sooo i was riding on the street and I fell... I think my gas might have leaked when I fell and sparked on the pegs or engine? I don’t know but when I got up and turned around which wasn’t even a second later the bike was on fire. I ran with it across the street and put it out.

Madmack Added a reply to 2005 yz125 won’t roll in gear w/ clutch in

1/16/2021 8:04am
A dime is 1.35mm so I’ll just take 2 of them. I noticed My lever has some slop in it maybe it’s the original but I’m probably going to swap the assembly soon. I’ll take the measurement in a few hours and keep you updated. I changed the oil just in case that played a roll in it