Recent Activity

All

wwdiii Liked a reply to forum topic Guts tall seat on KX 250/450 2020+ ?

1/3/2025 12:34am
I plan to put a taller seat on my on my 24 KX450 I just picked up. I’m only 6’2 ish but have really long legs. I have Guts tall 30mm foam on my Beta 300 RX and my 23 Honda. Once the foam breaks down it’s not as high. I couldn’t tell any difference in handling but I’m old and slow. Guts has a 20mm height also, which I may try this time. I also lowered the pegs on both my Beta and my Honda. Haven’t lowered the pegs on my new KX but will over the weekend.
This forum topic has 26 replies.

jDavo#31 Started a new thread Oil behind clutch plunger?

6/5/2024 7:57am
What happens if oil gets behind the clutch plunger and also what would happen if you pull the plunger out whilst changing a clutch pack. After changing my last clutch on my 23 kx450 it ends in a really stiff spot closer to the bars and it wasn’t like this when new.
This forum thread has 0 replies.
Hi just looking for if there are any forks or products that support External High Speed Compression Dampening in forks. Kreft and Krooztune look like good options said below. "just looking for external mid valve control (high speed) so i can have constant and consistent dampening through the whole stroke. low speed dampening mixed with the right oil level controls...
This forum thread has 9 replies.
As I wrote in your other thread, perhaps Kreft. Ohlins and other cartridge makers, too. $$$$$€€€€€££££
This forum topic has 9 replies.
I'm not sure, but I think Kreft may have something along the line of what you are after.
This forum topic has 7 replies.
Hi just looking for if there are any forks or products that support External High Speed Compression Dampening in forks. "just looking for external mid valve control (high speed) so i can have constant and consistent dampening through the whole stroke. low speed dampening mixed with the right oil level controls the low speed stuff and spring rate controls the...
This forum thread has 7 replies.