2006 kx65 no start help!?

motocross_moe27
Edited Date/Time 1/19/2018 4:48pm
Hey guys I have a 2006 KX 65 and it’s a no start I did a compression test with my finger is pulling and pushing, I sprayed starter fluid into the spark plug hole still No start! Cleaned the carb, I switched out CDI box/computer with a different KX 65 of the same year still no start, this is all after a new piston (generic) somebody help please?

|
Falcon
Profile picture for user Falcon
Posts
12613
Joined
11/16/2011
Location
Menifee, CA, USA
Falcon 1/17/2018 2:16pm
1/17/2018 2:16pm
Go back to the basics. Do you have spark? Fuel getting to the carb? No rag in the airbox?

Spark, fuel/air mix, and compression are all she needs.
crf250pilot
Profile picture for user crf250pilot
Posts
2133
Joined
4/1/2008
Location
Manning, OR, USA
crf250pilot 1/17/2018 3:13pm
1/17/2018 3:13pm
Check for spark by pulling plug, connecting it back in the boot and grounding the electrode to cylinder while you crank it over. If no spark, i'd suspect the stator is bad.
kzizok
Profile picture for user kzizok
Posts
8428
Joined
10/19/2010
Location
USA
kzizok 1/17/2018 3:40pm
1/17/2018 3:40pm Edited Date/Time 1/17/2018 3:42pm
Help!,

Tamir?
Dirty Points 1/17/2018 3:50pm
1/17/2018 3:50pm
Clearly you are missing both the cylinder and cylinder head.

The Shop

See All »
Acidreamer
Profile picture for user Acidreamer
Posts
1793
Joined
8/25/2015
Location
Mansfield, OH, USA
Acidreamer 1/17/2018 4:02pm
1/17/2018 4:02pm
You did a compression test with your finger?!? Wtf?!? Dude that generic piston probably isnt even the right size and you have like 50psi. Get a good compression tester and get a reading.

Also did you put gas in it
dadofagun
Profile picture for user dadofagun
Posts
2057
Joined
3/28/2015
Location
Satan's Hollow, OK, USA
Fantasy
592nd
dadofagun 1/17/2018 5:03pm
1/17/2018 5:03pm
Disconnect the kill switch, then give it a kick. My sons 65 back in 07 had a faulty kill switch and it grounded out the whole machine, no start. Hope it helps, good luck
Rockinar
Profile picture for user Rockinar
Posts
1063
Joined
9/16/2016
Location
Katy, TX, USA
Rockinar 1/17/2018 7:07pm
1/17/2018 7:07pm
So you went from a YZ250F to a YZ65?

Did you take your time machine back to your 65 days? Tell us how. Help!

Much ty!
motocross_moe27 1/19/2018 1:44pm
1/19/2018 1:44pm
Dirty Points wrote:
Clearly you are missing both the cylinder and cylinder head.
Oh crap your rite, I put that on and it fired rite up thanks bud your the best!
motocross_moe27 1/19/2018 1:46pm
1/19/2018 1:46pm
Rockinar wrote:
So you went from a YZ250F to a YZ65?

Did you take your time machine back to your 65 days? Tell us how. Help!

Much ty!
We’ll see what happened was, I made a wish to be young again and it worked! You should try it www.Douchebag.com/youngAgain
motocross_moe27 1/19/2018 1:49pm
1/19/2018 1:49pm
dadofagun wrote:
Disconnect the kill switch, then give it a kick. My sons 65 back in 07 had a faulty kill switch and it grounded out the whole...
Disconnect the kill switch, then give it a kick. My sons 65 back in 07 had a faulty kill switch and it grounded out the whole machine, no start. Hope it helps, good luck
Thanks man it was the “cheap piston” I put an oem piston in and it fired up, the guy who I got it from lied and said he (just replaced the piston and gave me the old box,receipts, ect and I noticed it was an off brand so as a last ditch effort I replaced it thanks
motocross_moe27 1/19/2018 1:52pm
1/19/2018 1:52pm
Acidreamer wrote:
You did a compression test with your finger?!? Wtf?!? Dude that generic piston probably isnt even the right size and you have like 50psi. Get a...
You did a compression test with your finger?!? Wtf?!? Dude that generic piston probably isnt even the right size and you have like 50psi. Get a good compression tester and get a reading.

Also did you put gas in it
Yo bro lol I heard of someone doing it with there finger so i tried it, nevertheless it was the generic piston I replaced it with oem and it worked... question since your the only one who figured it out... (I have 3 kx65) now my other kx65 starts but when I put it in gear it cuts off immediately! Question is bad clutches or carb adjustment? Thanks man
motocross_moe27 1/19/2018 1:59pm
1/19/2018 1:59pm
Hey guys I got it fixed it was the piston thanks... but if it’s not to much trouble to answer one more question?

So I have 3 kx65, the (1) generic piston bike is done,
(2) 06 kx65 again, starts fine but when I put it in gear it cuts off immediately, also sometimes Boggs down when given gas at idle, carb rite? But do what? And how??

2003 Kx65 (#3) needs piston hopefully Itll start and run fine after build but keep an eye out for questions lol I appreciate guys thanks
Rockinar
Profile picture for user Rockinar
Posts
1063
Joined
9/16/2016
Location
Katy, TX, USA
Rockinar 1/19/2018 3:17pm
1/19/2018 3:17pm
motocross_moe27 wrote:
Hey guys I got it fixed it was the piston thanks... but if it’s not to much trouble to answer one more question? So I have...
Hey guys I got it fixed it was the piston thanks... but if it’s not to much trouble to answer one more question?

So I have 3 kx65, the (1) generic piston bike is done,
(2) 06 kx65 again, starts fine but when I put it in gear it cuts off immediately, also sometimes Boggs down when given gas at idle, carb rite? But do what? And how??

2003 Kx65 (#3) needs piston hopefully Itll start and run fine after build but keep an eye out for questions lol I appreciate guys thanks
Endless loop troll questions. HELP!!!

Much ty!
rohleder644
Profile picture for user rohleder644
Posts
1054
Joined
1/18/2011
Location
Lee’s Summit, MO, USA
rohleder644 1/19/2018 3:25pm
1/19/2018 3:25pm
Am I just that naive? I don't see any "troll" red flags. Kinda just seems like a guy looking some bike help on the biggest motocross forum out there.
dirtmike86
Profile picture for user dirtmike86
Posts
1215
Joined
10/28/2015
Location
Grand Terrace, CA, USA
dirtmike86 1/19/2018 4:16pm
1/19/2018 4:16pm
rohleder644 wrote:
Am I just that naive? I don't see any "troll" red flags. Kinda just seems like a guy looking some bike help on the biggest motocross...
Am I just that naive? I don't see any "troll" red flags. Kinda just seems like a guy looking some bike help on the biggest motocross forum out there.
Its the vital way. Easier to assume everyone is a troll.
Rockinar
Profile picture for user Rockinar
Posts
1063
Joined
9/16/2016
Location
Katy, TX, USA
Rockinar 1/19/2018 4:48pm
1/19/2018 4:48pm
rohleder644 wrote:
Am I just that naive? I don't see any "troll" red flags. Kinda just seems like a guy looking some bike help on the biggest motocross...
Am I just that naive? I don't see any "troll" red flags. Kinda just seems like a guy looking some bike help on the biggest motocross forum out there.
They will ask goofy questions as long as you keep answering them. You really buying that nonsense that the bike would not start cause it had a "generic" piston in it? Like Wal Mart sold it to them and it was a dud. LOL.

Keep your eye out for more question!

Much ty!




Post a reply to: 2006 kx65 no start help!?