Posts: 120
Joined: 12/18/2009
Location: Knoxville, TN USA
Hey guys I picked up a 7x12 Enclosed Trailer. I am wanting to set it up for Moto over the winter. If you have one set up or have seen something nice looking post a picture or pictures up. I am just looking for some ideas. I bought pretty much a base trailer.
Posts: 244
Joined: 4/1/2008
Location: East, TX USA
Check out this thread
http://www.vitalmx.com/forums/Moto-Related,20/help-setting-up-a-trailer,1294825
Posts: 548
Joined: 4/1/2008
Location: Salt Lake City, UT USA
This is my 6'x10' Haulmark. It just had the typical thin luan on the walls and plywood on the floors, as all do. I gutted it down to bare metal, installed 3/8" plywood on the walls for strength, then covered the plywood with the finishing panels for a smooth paintable surface.
The bench at the nose is obviously really useful. Under that is a small box for a battery to power the LED interior lights.
The driver's wall has Gladiator tracking with the cabinet you see, and the metal tracking down low is great for securing quite a bit of stuff.
The floor is the OEM plywood, but with an epoxy coating (I have an epoxy flooring business). Pretty awesome for keeping it clean.
Posts: 1398
Joined: 5/4/2009
Location: Colgate, WI USA
Posts: 444
Joined: 2/16/2007
Location: Austin, TX USA
Hey KGASpeed, hope you dont mind me asking, is there any special prep/primer needed for the epoxy flooring to stick to plywood?
Posts: 548
Joined: 4/1/2008
Location: Salt Lake City, UT USA
HackMan162 wrote:
Hey KGASpeed, hope you dont mind me asking, is there any special prep/primer needed for the epoxy flooring to stick to plywood?
Don't mind at all, and no, I just sanded the plywood with 80g & 120g to make sure it was smooth, clean and able to accept the epoxy. It will soak into the wood quite a bit, so be prepared to put it down heavy.
When I first built the trailer, I just used "porch and floor" oil-based paint from Home Depot. That actually works fine, but its not nearly as durable as the epoxy.
Posts: 6
Joined: 12/27/2014
Location: CAN
Edited Date/Time:
I just finished my 7x12 motocross trailer
The bench slides out to fit a twin bed mattress for over night races.
Posts: 2633
Joined: 3/11/2013
Location: San Clemente, CA USA
Posts: 338
Joined: 7/13/2014
Location: Tulsa, OK USA
Posts: 2633
Joined: 3/11/2013
Location: San Clemente, CA USA
Picked up my 7 x 10 today. It's only 6' 6'' inches tall so it fits in my garage. Time to start setting it up. Here's the details.
7 x 10, wheels inside box
2 front doors, one on each side
50 gallon water tank with pump and hose bib
Dome light with wall switch
