Lives in:
Darwin, NT, AU
Member Since:
8/16/2023
Recent Activity
All
nathanholstein Added a reply to 1992 RM125 completed...updated pipe
8/25/2023 4:36am Any one know if can get these white and pink covers anywhere?
More »
nathanholstein Added a reply to 95 Honda CR250 forks and clamp swap
8/22/2023 4:30am What brand are these?
JordanFeigenbaum Liked a reply to forum topic 2022 RM 250 AF
8/18/2023 4:07pm
Bearuno is correct, the pivot to cases mount is stock. The plates at the front and top mount were custom made by Nihilo. As I recall, it wasn't terribly hard for them to make while preserving the relationship between pivot bolt and countershaft sprocket center of the RMZ-250. In bike news, the OEM stator went out while I was riding last week. Ordered an OEM replacement and coil. I suppose the motor is nearing the 20-years old mark, so this was bound to happen at some point. The bike has a JD ignition programmed by PC in 2015 for previous...
This forum topic has 52 replies.
nathanholstein Added a reply to 2022 RM 250 AF
8/16/2023 4:22pm Just dimensions of the engine mount on the front they have used? Did this allow the use of a stock airboot to the carb? I presume bottom engine mount is the factory one? and top one can be measured and made once front of engine is set in place.
nathanholstein Added a reply to 2022 RM 250 AF
8/16/2023 5:01am Hi mate nihilo don’t make these mounts anymore. You wouldn’t be able to measure them? thanks