Recent Activity
All
Lesko34 Added a comment about blog post 2018 yamaha yz450f problem , cutting out when wide open
5/30/2020 2:52pm
Did you end up figuring it out? My 19 is doing the same thing right now
This blog post has 3 comments.
Lesko34 Added a reply to Yz250 starts but bogs and shuts off
1/23/2020 8:40pm
Lesko34 Added a reply to Yz250 starts but bogs and shuts off
1/23/2020 8:38pm Thanks everyone. Finally figured it out after days in the shop. The power valve has a stopper on it that when it fully opens it stops against the cover that is on the front of the cylinder. Well the stopper which is pretty small broke off and was stuck under one of the cam looking things (called pulleys i think)...
Lesko34 Added a reply to Yz250 starts but bogs and shuts off
1/23/2020 7:06am I thought of this also because i did have one where the reeds go while i had it apart but i know i took it out. Im gonna double check though just incase maybe a piece got stuck or something
Lesko34 Added a reply to Yz250 starts but bogs and shuts off
1/23/2020 7:05am I did clean the filter in the petcock and the crank seals have never been done that i know of. I bought it used with not many hours on it. Ill check the float and needle today
Lesko34 Added a reply to Yz250 starts but bogs and shuts off
1/23/2020 6:02am Just pulled the jets
Lesko34 Added a reply to DIY seat foam
1/22/2020 9:17pm I once had seat foam break down from getting wet. I took the cover off let it all dry out real good and then took a thin yoga mat probably about 1/4” thick or so and cut it to fit over the foam. Then i stretched the cover over it and the seat is now more firm and is raised...
Lesko34 Started a new thread Yz250 starts but bogs and shuts off
1/22/2020 9:13pm I have a 2011 yz250 i use as a woods bike. I noticed the other day it started to get just a split second lag in power when i get on the throttle. I took the carb apart and the pilot was a little plugged up. I cleaned it out and even jetted it with a 45/172 to lean it...
This forum thread has 11 replies.
Lesko34 Added a reply to Stripped oil drain threads
12/17/2018 1:25pm I was gonna try a timesert kit but they are expensive. Probably gonna end up pulling the motor and tap it
Lesko34 Started a new thread Stripped oil drain threads
12/16/2018 8:05pm I have a 2017 yz250f with a stripped oil drain hole. It is the threads in the case and the way they have it near the frame you have to take the motor out to tap it. Any other ideas? Thanks
This forum thread has 12 replies.
Lesko34 Added a comment about feature 12 Days of MXmas: Boyesen
12/15/2018 7:25am
Would be perfect for my 2 stroke
This feature has 268 comments.
Lesko34 Added a comment about feature 12 Days of MXmas: Leatt
12/15/2018 7:24am
Sweet
This feature has 316 comments.
Lesko34 Started a new thread 1998 kdx 220r fuel line
12/13/2018 7:02pm
This forum thread has 2 replies.
Lesko34 Added a comment about feature 12 Days of MXmas: ODI
12/13/2018 6:55pm
Need some new bars
This feature has 258 comments.
Lesko34 Added a comment about feature 12 Days of MXmas: Scott
12/12/2018 3:39pm
Want!
This feature has 335 comments.