All

I understand your frustration. I have seen bikes with the lever pulled the wheel spins freely. Also, I have replaced everything and still had a slight creep the first use. Recently had 2016 KTM 250FE that was stalling and creeping going into 1st gear on the first start up. We replaced everything at considerable cost just to have it do the same thing. On this bike we have to hold the brake and keep the rev's up the first time you use the clutch after sitting a day, after the clutch lubes and warms up it stops creeping in gear...

Nothing is wrong. Your bike will not roll like it is in neutral when in gear with clutch. Until hot oil gets in between the plates, usually from riding a few laps on a track at full whack, the plates might stick to each other and cause a stall at low rpm, i.e. when putting it into gear from neutral at idle rpm. You won't need to replace basket until bike does a jerking motion under engagement because the plates aren't sliding smoothly across the ears of the basket, and won't need to replace plates until it slips- you give...