All

I bought a brand new '01 cylinder and head from motosport. Then sent it to Procircuit for porting and head mod.

The yellow plastic came from the UK. Look up MX LEGENDS on facebook. Dudes legit and ships fast https://www.facebook.com/MX-Legends-843577302378143/

Man guys this thing rips! After getting the needle and main jet where it needed to be it pulls good down low and hits f!#@*^g hard in the midrange. It continues to pull up top but i dont have another decent running 250 to really get a good comparison of the high end. Its likes to be short shifted and...

I pressed the '05 stem out and pressed the '95 stem into the '05 clamps. New '95 bearings and seals. I used the spanner nut from the '95 but used the upper aluminum nut from the '05. Measure your height of the stem in the '95 before pressing it apart so you know you have the stem height correct. ...

I fit the 2001 works pipe today. Had to tweak the tail pipe alittle to clear the air box and bladder on the shock. Also cut the stock front mount off the pipe and rewelded it to work with the '95 frame. Its soooooooo close though! Im ready to ride it but its going to have to wait...

I hope to have it together this week end! Hopefully it runs!

Haven't posted in a while on this thing. Been busy with work and other projects but i can see the light at the end of the tunnel! Plus I've started building another track and rode my brothers yz450 the other day. Those brakes sucked! The ol' booter '95 smoked it on front brake with wore out pads and rotor! I...

Im easy to get along with, as long as the talk isnt about sissy quad stuff

Ill have to go back and look where i got mine. I just google searched for one and found a website selling them. I look for probably 3 months before i found these.

Yes it is coming together. Its hot outside so the wife let me bring it in to the dining room table! I cerakoted the cases sniper grey.

The case is fixed! Actually have the right side assembled with the crank installed and transmission gears back inside. Need a crank install tool for the left side to get the cases back together. Here's the busted right case after welding and running a boring attachment in the end mill to clean up the weld. It didnt like welding very...

The case is fixed! Actually have the right side assembled with the crank installed and transmission gears back inside. Need a crank install tool for the left side to get the cases back together. Here's the busted right case after welding and running a boring attachment in the end mill to clean up the weld. It didnt like welding very...

Yeah cases arent made any more. My other '95 has the bottom of the cases busted on it instead. I haven't fixed this case yet, just sitting on the welding table at work waiting for me to get time. The good news is i received some more goodies from the santa claus wearing brown last night.

I've got an '01 cylinder and head on the way brand new from honda and a honda crank/rod also. Hinson clutch plates and fibers along with springs. I dont think ill opt for a basket or pressure plate just yet- maybe next week lol. I split the cases tonight. Everything looked fine except for this little nasty. Was a little...

I got this seat cover from banana_oil on here. The way i understood it this cover was recently made by a friend of his that works there. Its a one off cover.