All

Sent you a pm

I like how you think! It works. I'll give you your money back if it doesn't. If the block works out, maybe you would be interested in a port job. A real port job. Like extra ports added, ect. Smooth broad reliable power. Stuff the pros didn't have back then (except for maybe some factory bikes).

Any way to private massage? $265 shipped

No carb mods needed. Flop back & forth at will between the stock block & new one. Works great with from stock to mod. The block is made to work with similar to stock jetting. Basic setup is a bump in the main of around 5 sizes & a pilot of around 45-48. I offer mods to carburetor. Some mods...

Let me know if you need one...or more. Others may offer it but NONE are getting as much power out of it that I am. The tuning process is key. It's simple but different. I have a specific tune for this block to allow for just under a 5hp gain through the meat of the powerband. I will set a...

Thank you

What's the title of the thread where he did the transmition?

Lol yeah I thought that was a pretty cool choice for graphics. Thanks for the direction on the tank.

Looks sick man! I like the Santa Cruz screaming hand. I was just telling a buddy (pretty good skater) of mine to do the Rob Roskop face on his kawi shrouds. Where is that tank from again? I'm not feeling going through the thread to find it out. Beautiful build. I'm in the middle of doing up my 2006. Got...

Yes, it was at Varner's. I had been talking with him as he conducted the test. I have been against the .031" block since the first time I tested the prototype early last summer. As I rode the bike, I could sense an ever so slightly wavering in power...ever so slight. I immediately knew that the .031" was too big...

Derek, What was my suggested jetting that was too lean? What is your suggested jetting? Which bike or needle in the jetting equation? I have NEVER suggested anything too lean so I'm not sure where you get that from or why you say it. Email me or call me. We are the designers, manufacturers, & wholesalers. Derek is one of...

Sounds good.

Ok. What sort of deposit does he want? I saaume we send the payment to him?

Yes count me in. I'll ask a buddy who will probably take one also. He is done with work shortly. I'll let you know on #5.

What is the cost of the front (with bracket) & rear rotor kits? I'm interested in a set.

This bike should have one of these. Almost 5hp through the meat of the powerband. If you're interested, email me at: Keithpeterson75@gmail.com I'll tell you more about it & where you can get it. Very nice bike!