Recent Activity
All
combatmx Added a reply to Kick start assembly
4/12/2017 2:03pm Wow i just bought a 2017 yz 250 and had to kick it more then once and it felt like it stripped kick starter gears or the clutch basket gear the bike might have 4 hours since I picked it up at the dealer.I can believe you broke the cases that's yam ha saveing money.I'm not sure what to do...
More »
combatmx Added a reply to Project bike: 1986 Honda CR125R
4/12/2017 10:04am I have a nice clean tank for 87 Cr 125 and allso silver rims with drum brakes good tires and I will give ya the front brake cable with it and what ever the rear brake has if u want TeX me 914-424-6477 and we can come up with price
combatmx Started a new thread anny bearings for bikes
4/12/2017 9:53am If anyone needs wheel bearings or motor bearings call Chris at World Wide Bearings out of NJ he can make anny bearing you need.Thair is a bearing on a 88 Cr 125 that gets locked into the cases buy 2 tabs I think it was for the out put shaft for the trans well I found them on eBay and...
This forum thread has 1 reply.
combatmx Started a new thread 88 Cr 125 transmission issues
2/6/2017 3:08pm I need help both trans shafts move in and out not a lot but not sure to do
This forum thread has 1 reply.
combatmx Added a reply to Should I ride it or not?
2/6/2017 2:58pm Dam not sure its so dam clean in and out you know what screw it ride it .wer heer once ride brother ride
combatmx Started a new thread 88cr 125 trans
2/2/2017 5:55pm Does annyone know if thair is movement in the trans sprocket shaft moves in and out a little.or is the trans shaft not supposed to move at all.I'm trying to put bottom half to gather and it shifts fine but when I try to spin trans by hand seems a little tight anny info will help.I have the washers and...
This forum thread has 0 replies.
combatmx Added a reply to 1988 Cr 125.
1/3/2017 6:52am Annybody have anny 88 Cr 125 parts I found this bike in a scrap yard and I'm starting to locate parts and nobody sells a complete crank kit for the 88 so I guess I'm gunna press a new rod in.and I have a few extra parts I don't need OK TeX or call if anyone has info don't care...