Recent Activity
All
banshee Added a reply to Polished Swingarm ? How to get it back to the factory look
4/28/2018 6:45pm if your swing arm is already polished I don't think you'll need the sand paper flap disc. 
More »
banshee Added a reply to Polished Swingarm ? How to get it back to the factory look
4/27/2018 6:34pm as follows. 1.battery powered angle grinder with a half used flapper disc 2. poly flap disc on grinder 3. think it was 1000 grade sand paper in a up and down motion 4.wet and dry sand paper 5.Scotchbrite in up and down motion Some people may not agree with the method but it was the only way of getting it...
banshee Started a new thread 1994 CR250
4/27/2018 12:46am
This forum thread has 21 replies.
banshee Added a reply to 1994 CR250
4/27/2018 12:46am new pipe arrived and fits quite nice, fitted some graphics and got my new rims and cloth bar pad 
banshee Added a reply to 1987 RM250
4/25/2018 1:03am mint !!!!!
banshee Added a reply to 1994 CR250
4/20/2018 8:41pm Cheers mate wasn't 100% sure which way they went I'll change them
banshee Added a reply to 1994 CR250
4/20/2018 8:39pm Best bet would to start searching Ebay and vintage bike ads and even vintage fb pages the hard one to find is the rear fender.
banshee Added a reply to 1994 CR250
4/19/2018 6:17am
and peic 
s 
banshee Added a reply to Violet kx250
4/18/2018 5:01am I have the same cover just different colours 
banshee Added a reply to Violet kx250
4/18/2018 3:53am
banshee Added a reply to 1994 CR250
4/10/2018 7:29pm
banshee Added a reply to 1994 CR250
4/10/2018 6:33pm
banshee Added a reply to 1994 CR250
4/1/2018 4:42pm thanks mate the plastics are ufo but no longer made
banshee Added a reply to 1994 CR250
4/1/2018 2:15am
banshee Added a reply to 1994 CR250
4/1/2018 1:18am thanks mate it was a lot of scrubbing haha
banshee Added a reply to 1994 CR250
4/1/2018 1:17am Yeah no probs mate the cylinder and swing arm were both vapour blasted and I didn't have to do anything else to the cylinder but as you can see the swing arm was in really bad shape with quite deep pitting and the only way I could fix it is as follows. 1.battery powered angle grinder with a half used...
banshee Added a reply to Another '95 CR250 build
4/25/2017 12:22am Nice mate im building the same bike by the looks of it but I need a seat cover like yours....... 