VForce reed 79-80 Honda CR125

Mike P.
Profile picture for user Mike P.
Posts
756
Joined
11/3/2014
Location
Chantilly, VA, USA
Mike P.
Edited Date/Time 8/14/2015 3:57pm
Has anyone ever fitted a set of VForce reeds to a 79 or 80 Honda CR125 and if so, which ones did you use?
|
mb60
Profile picture for user mb60
Posts
5705
Joined
3/7/2010
Location
GRAPEVINE, TX, USA
mb60 8/14/2015 2:13pm
8/14/2015 2:13pm Edited Date/Time 8/14/2015 2:13pm
I went around and around on this with a 1983 RM 125. Just take the stock reed block out and measure from center hole both length and width. Get with the place who makes the V Force 3 and he can send you the measurements they have.
Make sure you measure center hole to center hole.
nakedmonkey
Profile picture for user nakedmonkey
Posts
9
Joined
4/2/2008
Location
San Clemente, CA, USA
nakedmonkey 8/14/2015 2:21pm
8/14/2015 2:21pm
Mike P. wrote:
Has anyone ever fitted a set of VForce reeds to a 79 or 80 Honda CR125 and if so, which ones did you use?
used V force3 on 1980 CR125. Works great.
Lonestar_399
Profile picture for user Lonestar_399
Posts
600
Joined
2/15/2009
Location
Dallas, TX, USA
Lonestar_399 8/14/2015 3:35pm
8/14/2015 3:35pm
What's the model number used?
RiV
Profile picture for user RiV
Posts
90
Joined
2/7/2013
Location
Midvale, UT, USA
RiV 8/14/2015 3:57pm
8/14/2015 3:57pm
If you don't find a good match, the early V-Force separates from the
outer flange. It's the a matter of making a flange that adapts it to
the main reed block, done it a couple times and it works great.

Post a reply to: VForce reed 79-80 Honda CR125