Recent Activity

All

scotgary Started a new thread 06 RM 250 coil specs

10/1/2018 6:30pm
I am still trying to resolve my hot starting issue. When warm, it takes about 6 good kicks for it to start and will only do so with wide open throttle. Lately, if it doesn't start, it floods. I just raised the float height and will try that. I went through the electrical and now have this question: How far...
This forum thread has 1 reply.

scotgary Started a new thread Rekluse cover RM250

10/5/2017 5:49am
Hi guys, I am in need of a Rekluse clutch cover for my 06 RM250. They are discontinued. Does anyone have one or know of where there may be one. The height of the Rekluse in the Suzuki requires the use of two of their 1/8in. gaskets stacked together. We have broken a number of covers due to the give...
This forum thread has 0 replies.

scotgary Started a new thread 06 RM 250 Hard to Start

9/11/2015 8:38pm
This bike has always ran fine. Now it will start cold with choke on in about 4-5 kicks. Once it is hot it takes about 6 kicks with wide open throttle to get it to light. The carb is clean, float level is correct, compression is good and gas is fresh. The hot starting with wide open throttle only seems...
This forum thread has 10 replies.

scotgary Added a reply to 06 RM 250 Hard to Start

9/10/2015 2:20pm
Service manual states 0.4 -0.7 on the primary side and 13K - 20K in the secondary. The needle does seat completely. If I shut the bike down even for a minute, it needs full throttle to restart and there is not enough time for fuel to leak past the needle and seat to flood it. The pilot is clear.

scotgary Added a reply to 06 RM 250 Hard to Start

9/9/2015 5:18pm
Stator and flywheel are clean. Coil specs out good. Primary 0.8 ohms, Secondary 17K ohms. Good spark. Again, it runs very well once started, but will only start with throttle wide open after about 6 kicks. It acts as though it was flooded, but that is not the case.