All

Hey I'm In the Whitsundays, not sure of anyone in my area but I would think there would be someone who does hard anodising in Mackay or Townsville, Maybe try this guy from this thread http://m.vitalmx.com/forums/Race-Shop,42/2008-RM125-Rebuild,1283129?pag… noticed he's from Mackay and on about page 4 he has some really mint looking anodised parts....would be keen to know if there is...

Brakes all done, new seals, plungers, pads etc and abit of a clean up

Yeah so that's basically what I did, this is what I ended up with-a huge improvement over my last effort....might have to walk past it a few times though to see if I'm happy with it or if OCD kicks in and I resand etc to try get an even better finish

Have been having a look through some threads and videos, i'm thinking/hoping where i went wrong was perhaps the drill i had the buffer pad on wasn't powerful enough and I also went pretty conservative on the scratch and swirl after watching the videos. Going to give it another shot today.........also in the middle of rebuilding the fr/rr brakes, looks...

Sweet, have just sent you a message.

So this is where I am up to after sanding and re sanding, just can't seem to not end up with a dull finish. Anyone got any tips?

Thanks, I have contacted a local supplier (Australia) to see what they are able to do. Cost of shipping from O/S countries at the moment is unreal.

I was also wondering if anyone has had any experience in replacing the seat foam on their bikes? i see Factory FX sell replacement foam, how is this reattached to the seat base? Thanks