Recent Activity

All

mx4life92 Started a new thread rm 125 help

1/26/2012 3:08pm
i know this is the wrong place to put this but no one ever checks the tech part ok recently my top end seized up so i had to get it repaired, i had to have the cylinder bored to a 56.00mm (stock is 54.00mm) i installed a wiseco .80 piston. so i put it back together and added a...
This forum thread has 30 replies.

mx4life92 Started a new thread what do you guys think my bike is worth

1/26/2012 5:39am
2000 rm 125 brand new top end and bottom end wiseco .80 pison and cometic gaskit kit brand new clutch has vforce 3 reeds bills silencer bills pipe renthal bars asv clutch and brake levers (the ones that cant be broken bends both ways) renthal chain and sprocket twin airfilter extras full top end rebuild kit brand new mx51 rear...
This forum thread has 13 replies.

mx4life92 Started a new thread 2000 rm 125 help

1/21/2012 4:56pm
ok recently my top end seized up so i had to get it repaired, i had to have the cylinder bored to a 56.00mm (stock is 54.00mm) i installed a wiseco .80 piston. so i put it back together and added a new twin air air filter while i had the seat off, well now i went ridding today to...
This forum thread has 6 replies.

mx4life92 Added a reply to good deal

2/16/2010 2:37pm
im not interested in it because stewart owned it, it just seems like a dialed bike.

mx4life92 Added a reply to rm 125 help

2/14/2010 11:02am
bike is a 2000 rm 125, and on the oil it says do 50:1, i use it in my yz 125 my brother uses it in his 05 rm 125 and theres no problems at all. i will try changing the reeds, and will take a look at that jetting guide

mx4life92 Added a reply to rm 125 help

2/14/2010 1:19am
when i got it the top end and bottom end were brand new i actually picked it up from the repair shop, so it was running good, then i put about 30 hours on that top end before it went out, and everytime before the spark plug goes out it runs but no smoke at all, but right when i...

mx4life92 Added a reply to rm 125 help

2/13/2010 8:22pm
the previous owner had it sleeved.... and i didnt bore it myself i took it to a well know mx repair shop

mx4life92 Added a reply to rm 125 help

2/13/2010 8:12pm
before fouling it runs amazing, and no the gas was fresh as i mixed it just before i went ridding. i followed the directions on the oil which say run 50:1, i use this same fuel mixture in my yz 125 and there is no problems at all. so which jet should i change it to i dont know what...

mx4life92 Added a reply to good deal?

1/18/2010 6:45pm
i will check the oils and filter and make sure to start it cold cause the last one i looked at the guy wouldnt let me start it cold