All

Thanks guys, I'm guessing this Tom guy lives in the USA? I'm from the UK. I agree these engines are totally crap. This bike will just be used for bashing about, I have a sxf 250 and a tm mx 250 for the proper stuff.

Got the carb off today and had a look at the jetting. Forgot to check the air screw. It is as follows Needle, 3rd clip Pilot, 55 Main, 165 Slide, 5 Keihin pwk s63a1haa Judging by the above article its not the correct jetting. Is this right?

Thanks for the reply chaps. Aside the carb issues the bike needs a lot of other work. Unfortunately I'm completely new to carb settings. I don't know the ins and outs of jets, if it's rich or lean. The most carb work I've done is fitted a jd get kit to my ktm, and even then I had help with...

Sorry I didn't meet everyone's expectations, the cover has sold and the buyer is anonymous, however it went for 400. If I missed out on 500/600/700 ect then that's my problem. I simply didn't have enough time to reply to everyone. No need to be bitter.

Hi guys, for the short time this has been up for I've been littered with so many offers and emails, I apologise to anyone who didn't get a reply but I must have got in excess of 20+ mails. And I've not had time to reply to them all. The cover has now sold to the highest bidder pending payment...

Hi guys, so the bike has been completed. For now. Still some small bits needing attention. Yesterday was the first time out on the bike. Just doing some enduro at a local track. The bike fired up okay then died after a while idling. New plug and it was good to go. However. After a full day riding I noticed...

Hi guys, small update. Got my clutch bolt sorted. Drilled a small hole in the bolt and it just turned out no bother. Must have been a weak bolt. Got some goodies from kawasaki, new radiator guards, new brake pedal spring, stI'll waiting on new frame protectors, some frame protectors clutch bolts and a rear reseviour. Eventually got some pressure...

Ah, thanks. I didn't know it was a trough hole. That's by far the best option. I'll be giving that a shot when I can. As for frame guards I'm struggling to find a set of metal ones. I have the plastic ones but they are a bit shabby.

Hello again chaps, I have finally got my back wheel assembled, the bike is looking good. ( in my eyes) some small issues. Can't get pressure in back brake. Tried back bleeding, that one way valve method, keeping pressure on the lever over night, and the usual open close method. Still no luck. But that's nothing compared to my luck...

That was my guess, however before it was all stripped the brake made more pressure. I have heard it can be a pain but for me this is taking the biscuit! I'll persevere for now until I get sick.

Been 7 years since I rode, I'll end up eating mud the second I get on the bike.....

In Scotland its cold so no need to worry about heat

I've got the 304 shorty. Still looking for a header. I regret putting it together too quickly. I wish I could have stripped everything and cleaned it all. But hey itching to ride the thing. Having major issues bleeding the front brake. I cannot seem to get any pressure in the lever, still going right back to the bar. I've...

Got it for £65 GBP not sure if it's worth anything major. Just don't seem to see any at all.