All

looking to buy it, hes asking $3200 and is local to me, he said someone offered him $2,800 for it

I have a 18V Milwaukee impact driver that I use but this is the very top bolt in the pic that go's through the frame as well and cant get to it with anything except wrench or breaker bar, Just snapped a 14mm 6 point socket, now looking to see if I have one thats a impact socket (thicker wall)

this is where I am stuck at now, seems like the bolt has welded itself to the inner bearing surface, penetrating oil and hammer isnt working so I may have to move towards a torch and air hammer next but it looks as if this may be a common problem on these older bikes. I have been following Matt...

this is the end that I drilled out (no more threads), you can see where it starts to taper towards where the threads were, this had maybe 1/8" of play back and forth so it was a good thing as I had to replace it anyways

OK, i could not for the life of me was able to get a socket on the swing arm nut so i just ordered another one and drilled this one out (9/16 was the magic drill bit size), as you can see in the pic the nut was bigger than the original, I have no idea how someone was...

I also found two cracks on the rear mono shock mounting bracket, looks like its bolted on but I havent been able to find anybody parting one out so i can just get that part, I think I may be able to weld it

although I did get stuck at the swingarm nut, video I watched said its 22mm, wont fit, looked it up on parts and says its 16mm (92015-1316) http://www.kawasakipartshouse.com/oemparts/a/kaw/500b23f2f8700223e478ca… (way too small) a 24mm socket wont fit in the hole...... 23mm? maybe lol, I dont have a 23mm socket so thats why i havent tried yet

slowly getting it apart

thanks for the info, just placed an order for the Boyesen rad valve for this (RAD-11D) as my intake manifold was shot and been looking all over just to see what parts are available, figured their would be a strong aftermarket for these older bikes but it seem like hit and miss

looks like the VIN is JKAKXRK17TA014520

I have been looking online for a rebuild kit for the 95-97 KX 125 and havent been successful so far, do they not make one for these years? I did find some for older and newer models just not those particular years, will another years kit work? if there is a thread that discusses this just point me in the...

No i didn't but now i will, i just thought what was listed was all they had available thanks for the links as well, the one guy is in the Netherlands lol

Any ideas where I can start looking for a seat cover and graphics like that? I have already been on Evo-mx.com, another thread on here someone suggested http://vintagebikeads.com/ any nudges in the right direction will be appreciated thanks for the replies

is this the 96 PC model?