Recent Activity
All
dsk360 Added a reply to 125/150/250/300 KTM/HUS/GG jetting thread
6/9/2021 3:55am I started at the settings in the first post. And playing with different settings led me to where it is today. I'm gonna go back to those settings and see how it runs again. Thanks again for the help
More »
digger Liked a reply to forum topic 125/150/250/300 KTM/HUS/GG jetting thread
6/8/2021 5:30pm
Yes, you may possibly need to use a 27.5 pilot in the heat, depending on how large of a notch you made.
This forum topic has 1234 replies.
dsk360 Added a reply to 125/150/250/300 KTM/HUS/GG jetting thread
6/8/2021 9:09am I followed the directions you gave earlier in the thread so about 3mm
dsk360 Added a reply to 125/150/250/300 KTM/HUS/GG jetting thread
6/8/2021 7:56am Thanks Digger. Those settings work with the notched #5 slide correct?
dsk360 Added a reply to 125/150/250/300 KTM/HUS/GG jetting thread
6/8/2021 6:19am It's a 19 150sx. I have also already done the jet block gasket. What needle should I try?
dsk360 Added a reply to 125/150/250/300 KTM/HUS/GG jetting thread
6/7/2021 12:07pm Hey AJ I've been following this thread for awhile and first off want to say thank you for all the great info. I've made quite a few changes to my jetting based on what I read here. Currently I'm sitting at 42-71 needle in the 2nd clip, pilot 30, main 480, and the air screw at 2 out. I did...
dsk360 Added a reply to 125/150/250/300 KTM/HUS/GG jetting thread
3/29/2021 11:41am What needle is stock in the 18?
dsk360 Added a reply to 125/150/250/300 KTM/HUS/GG jetting thread
3/29/2021 10:14am FGR01 thanks for the advice. I'll check it. Update on the jetting. I've been playing with all sorts of combinations. Nothing seemed to help. I finally took the plunge and filed the notch in the #5 slide and was very impressed with it. I can now influence the jetting with the air screw. Before it didn't seem to make a...
dsk360 Added a reply to 125/150/250/300 KTM/HUS/GG jetting thread
3/29/2021 9:47am Where is the power valve in the stock position?
dsk360 Added a reply to 125/150/250/300 KTM/HUS/GG jetting thread
3/26/2021 4:52am Hey AJ/ digger I have a 19 150sx. The jet block gasket is replaced. I recently got the #5 slide, the 42-74 needle, 490 main, 32.5 pilot, and the air screw at 1.5. I believe my bike came stock with the s-4 needle jet. If I putts around for a few hundred yards then get on it there is a...