Posts
52
Joined
4/10/2024
Location
Big Clifty, KY, USA
Edited Date/Time
3/26/2025 7:12pm
I ordered a 36mm screw top pwk. So I’ve seen some posts about random years cr jetting with a 38mm pwk. But haven’t seen anything for a 2002 with a 36mm.
Being as the stock jetting varies wildly depending on the years I’m curious if anyone with a 2002 has put a pwk on and what jetting/needle ended up with. Doesn’t have to be a 2002 or a 36mm, any advice on a starting point would be appreciated.
It currently has a #7 slide, cek needle 170 main and 52 pilot
Really just curious on where I should start so I can get a needle/ jets ordered
No one?
I would copy whatever the guys used with the 38mm setup. The #7 slide should be good for the 125. The most current 125 using a pwk 36mm is on the beta 125's.
Thank you
My 04 cr125 JM racing engine with a diff carb taper bore runs perfect. Not sure if u ever rode 1 but it was super finicky b4 engine mods. Now it runs super clean bottom to top & super strong pull.
Post a reply to: Cr125 pwk36 jetting