Posts
2
Joined
11/14/2024
Location
Dayton, NV, USA
Edited Date/Time
11/14/2024 7:08pm
Hello, I’m in some serious need of help. First time pulling apart the front forks on a 2013 RMZ 250. Got the damper side done no problem went to do the spring side and I don’t know what the previous person did but I cannot get the center bolt in done and now it’s completely messed. The head stripped out so I tried heat and still nothing. Used an extractor socket and the head completely broke off. What do I do now. Any help will be greatly appreciated
Weld something on the end of the bolt, or drill the bolt out, either way you will need to replace the bolt and any components you damage in the process, or buy some second hand forks!
Maybe you are not doing something right have you watched a video or read a guide? Either way you will need a new fork or some machine tools or aforementioned welder to get that apart.
The Shop
DeCal Works Huge Plastic Inventory of UFO and Polisport kits.
Luxon 4-Post Bar Mounts
$189.95 - $239.95
I've encountered this a fair few times over the years.
People either loctite the end cap / bolt in, or go for broke with a rattle gun etc in overtightening it, and /or use a rattle Gun with , half the time, a 12 point socket, with a 'leading edge curve' to it, thus ripping the short height / depth and hollow Cap corners and flats off.
I remove the top cap from the damper rod / cartridge, separate the upper from the lower leg, , 'captive' the damper rod / cartridge in the lower fork tube, and, then use a large bore (2" will do it, unless you've a WP52 fork to rescue ) lathe to hold the lower fork, while I machine the end bolt / cap / nut off.
*****Note ; it's wise to familiarize yourself with Exactly What the form of that end bolt / cap / nut is - There's a Lot of different types - so you can have an idea of how to machine it so the end of the cartridge will then be able to come out of the lug!. Do it right, and you have a chance of Not damaging the cartridge components at that end, nor the lug. I'm a TIG welder of over 5 decades of experience, but would Not try to weld something to the damaged end bolt / cap / nut .
It's a pain in the arse to fix, but it can be done. It's also provides a lesson in Not overtightening an alloy bolt, or using a Loctite or some such thing where you shouldn't, and, in using the correct tools and Torque setting to do up / undo something
Post a reply to: Front suspension center bolt help