No front break, fork, seal leak

Huskyboy95
Posts
59
Joined
6/9/2020
Location
Valley Center, CA, USA

I just put brand new brake pads and clean the rotor on my FX 350. Naturally a few days later my front left fork seals started leaking apparently got all over the rotor and the brake pads lost my front brake. Do you think if I clean the rotor thoroughly and use Parts wash. I can get the new pads clean enough to operate. Will I be able to burn the oil off the new pads and clean the rotor? Thanks for any suggestions

|
willbilly
Posts
416
Joined
6/28/2016
Location
Corpus Christi, TX, USA
7/22/2023 6:52pm

Should be able to clean the pads with brake cleaner or mineral spirits. I would lightly sand the on a flat surface with 60-100 grit in a figure 8 pattern to make sure all the baked in oil is gone. 

1
spimx
Posts
1316
Joined
3/25/2019
Location
Port Isabel, TX, USA
7/22/2023 10:10pm

Acetone is what I use and sand paper for sure. I have not tried burning the pads or rotor but I see no problem to try it. Let us know how it goes. 

 

You can get some acetone at CVA it's nail polish remover 

7/23/2023 9:27am

I'm curious if this worked. I've been chasing my front brake on my 2019 YZ250F that has just been not as grabby as I'd like for a while. I've tried new pads, rotor, braided line, motol 600 fluid, bled many times, zip tied the lever in for days, and cleaned the pad after I noticed a minor form seal leak at one point. It's driving me nuts.

Post a reply to: No front break, fork, seal leak

The Latest