Kx125 piston help

Craigyw1984
Edited Date/Time 3/10/2020 5:35am
I have a kx125 2001 and a piston which the previous owner supplied. According to the manual the l3-l4 cylinder bore is 54.000, however the Mitaka piston i have is 54.40. Will this be suitable? Its a recondition barrel pot with number 1939.
|
Paw Paw 271
Profile picture for user Paw Paw 271
Posts
3632
Joined
4/3/2013
Location
Benton, LA, USA
Paw Paw 271 3/8/2020 5:17am
3/8/2020 5:17am
You will have to get the cylinder measured.

Paw Paw
1
karlz
Profile picture for user karlz
Posts
112
Joined
5/16/2015
Location
GB
karlz 3/8/2020 7:50am
3/8/2020 7:50am
If the cylinder has had a steel liner fitted and been bored out to 54.50mm it will fit.
Craigyw1984 3/8/2020 4:44pm
3/8/2020 4:44pm
karlz wrote:
If the cylinder has had a steel liner fitted and been bored out to 54.50mm it will fit.
So ripped the engine apart and it has been sleeved although i cannot accurately size the bore with verniers, seems all my readings vary from 54.5 to 54.9mm. The piston is. 55 stamped and seems to be damaged, any ideas on the cause? The bore of the cylinder looks not too bad. Would it be best to have it accurately sized and order a piston based on that. Any help would be much appreciated.

The Shop

See All »
Craigyw1984 3/9/2020 1:21am
3/9/2020 1:21am
Craigyw1984 wrote:
[img]https://p.vitalmx.com/photos/forums/2020/03/08/409356/s1200_IMG_20200308_230302.jpg[/img] [img]https://p.vitalmx.com/photos/forums/2020/03/08/409355/s1200_IMG_20200308_230256.jpg[/img] [img]https://p.vitalmx.com/photos/forums/2020/03/08/409357/s1200_IMG_20200308_230530.jpg[/img] [img]https://p.vitalmx.com/photos/forums/2020/03/08/409358/s1200_IMG_20200308_231154.jpg[/img] [img]https://p.vitalmx.com/photos/forums/2020/03/08/409359/s1200_IMG_20200308_231159.jpg[/img]





Also the crank seemed good and tight although i spotted these marks, not affecting in any way. Cause?

Craigyw1984 3/10/2020 5:35am
3/10/2020 5:35am
Piston in back to front😬

Post a reply to: Kx125 piston help