All

Currently 70-80f at around 500f of elevation. I tried to measure the float height with a digital caliper but I couldn’t get a super accurate measurement. I measured it at around 7-8mm. I’m honestly not for sure where to take the measurement. I have seen a video of someone doing it by blowing into the fuel inlet and my understanding...

#5 slide S4 needle jet 42-74 second clip 35 pilot 520 main Air screw 1.5 I use 90 ethanol free pump gas mixed 40:1 with castor 927. I adjusted the power valve to 2.25 turns in from fully out. The jetting change from above helped a lot but I am still having a slight bog when rolling on the throttle...

I am mixing 40:1. I have replaced the jet block gasket. I’ll have to order the 42-74. Thank you for the help.

2021 tc125 vforce4r reeds FMF fatty and Powercore 2 silencer. I’m having a bog when I crack the throttle open. #5 slide from jd jetting S-4 needle jet, 42-75 second clip, 32.5 pilot 510 main air screw 1.5 turn out. Not sure about pv I have the tool ordered. I’m going to try a 35 pilot tomorrow.