All

Thumperrookie Started a new thread ISO motojack rack, ultimate mx hauler

8/21/2020 7:40am

Looking for a hitch bike carrier. I used to have a motojack rack and it was awesome and very secured. So looking for a used one or the other brand as well, mx hauler

This forum thread has 0 replies.

Thumperrookie Added a reply to KTM Service Manual PAPER??

10/24/2019 12:22pm

I think u have me mixed up with Subliminaltrips, I sent u a PM as well with my email. If u can email me the pdf or link to download it that would be awesome

Thumperrookie Added a reply to KTM Service Manual PAPER??

10/24/2019 7:13am

Could I get the one for the 17 450 sxf?

Thumperrookie Started a new thread Ktm 450 sfx shift lever seal

2/11/2018 6:42pm

My ktm is leaking oil from the gear shift seal. Bike only has 24 hours on it I feel this is unusual but I need to replace I. Anyone have a good method of getting the seal out? I don't want to remove the case or engine cover. Is it correct or ok to pull the seal out using a...

This forum thread has 8 replies.

Thumperrookie Added a reply to Ktm 450 sfx shift lever seal

2/11/2018 6:42pm

I got the new seal on but it stillleaks. Now I'm wondering if I have too much oil in the engine. While I had the seal out the bike was leaning to help from spelling oil, but the seal cavity or housing kept on filling up with oil. The leak before the seal change was no severe it would leak...

Thumperrookie Added a reply to Ktm 450 sfx shift lever seal

2/11/2018 1:25pm

Easier said then done. I can get a screw driver blade under the lip of the seal but I don't want to leverage of the shaft to pry the seal out. Also as I get the corner of the flat blade screw driver under the lip the seal just keeps bending out and no movement on the seal. Is just...

Thumperrookie Added a reply to Ktm 450 sfx shift lever seal

2/11/2018 12:32pm

I pre drilled a hole then used a metal screen. I tried to give it a quick pull a few times but the screw came out and the seal was still in there. I tried another hole but same results. So now I'm wondering how is the shop going to get it out? Do they need to remove the clutch...

Thumperrookie Added a reply to Wp aer48 fork ,air pressure chart?

1/25/2018 6:59am

Running the up? Does that mean u move the forks up the triple clamp to the 3rd line down from the top of the fork? I think that place more weight in the rear and would create more head shake? Or did u mean u ran the triple clamp up the fork tube to the 3rd line from the bottom...

Thumperrookie Added a reply to Wp aer48 fork ,air pressure chart?

1/25/2018 6:52am

Did u raise the fork tubes up the triple clamp to the 3rd line down from the top of the fork tube? Wouldn't this put more weight on the rear creating more headshake? I came off a Honda and I'm having a hard time turning the bike, feels "tall"in the corners doesn't want to "sit" down and get in the...

Thumperrookie Added a reply to Wp aer48 fork ,air pressure chart?

12/13/2017 11:00am

Digger29, when u state u run them up on the 3rd line, does that mean u moved the fork tubes up the triple clamp so the top of the upper triple clamp is flush with the 3rd line down from the top of the fork tube? Wouldn't that but more weight on the front end making head shake worse? Or...