06/30/14
The newer 4 stroke rear brake will work. I have a 2012 rear brake system on my 2004 kx 125.
i just put 2011 kx250f forks on my 04 kx 125. I had to use the triple clamps off the 250 and a trick engineering steering stop. the forks were 5mm longer than the 125 forks so i have to run them higher up in the triples.everything bolted right on.
are you looking for aftermarket? i have a stock set sitting around id sell cheap.
I paid $8800 otd for my 2020 yz450 back in May. I found them a little cheaper but I wasn’t driving 200 more miles to save $200 so i went with a dealer that was fairly close.
I just payed $8700 otd for mine. I priced around and couldn’t find it much cheaper so I just went to a dealer that was close. the Yamahas don’t seem to get the big rebates like the kawis do.
I have about 5 hours on my 20 yz450f and I’m super happy with it. I came off a 2019 150sx and was considering a 350 And actually rode a new husky and ktm 450 but I just couldn’t get comfortable on the ktm so I decided to change it up after I sat on a ... more »
I ordered These last fall and got hurt immediately after and never wore them. I have them in a size 10 and they fit a little tight so I thought 11s would fit me better but they are a little too big and I prefer the size 10s. $220 shipped in the lower
This forum thread has 1 reply
I just picked up a 20 yz450f. The bike I got rid of was a 19 ktm but the bike before that was a YZ250. I just couldn’t get comfortable on the ktm and a yz 250 is my all time favorite bike so I wanted to get back on a yami. I’m 5’10” and about 195# and ... more »
I got rid of my 2019 ktm 150sx and I have a few parts left. stock pipe and silencer $125 shipped Stock reed valve. $50 shipped rktek 100+ octane head insert. like new $125 shipped. the reeds and pipe only have a couple hours on them. text me if you would ... more »
This forum thread has 1 reply
It’s good stuff. I actually have a set of suspension there right now.
the Athena kit uses a flat top piston and the stock cylinder/head is setup for a dome piston, You need to get the specific Athena piston for their kit.
The yz 250 is the best bike made today imo, it is a proven platform that works good for everything. I currently ride a ktm150sx and have rode the 250sx, they are awesome bikes but my next 2 stroke will be blue most likely.
I'm 195lb b rider and run a 42nm rear spring and 127psi in the forks on my 19 150sx, the rear shock isn't perfect but works ok stock. I think the stock forks actually work decent, I've been mulling over getting it revalved but I really don't have problem ... more »
They will fit, you will need to use the wheel spacers off the 16.
I would think $1500-$1800 would be a good deal for that bike. You can find newer yzs for that price and have a lot better bike.
Do you have the bottom too? I need the set for a kx125 that I’m rebuilding.
I replied to it. Send me a text message. (814))952-0148
I need a set of triple clamps for an 11 or 12 kx 250f. The 06-10 have the same fork diameters but the offset is different. I may consider and set off an older bike, let me know what you got.
This forum thread has 4 replies
they sell the cables on the website for $35. Id do $300 shipped.
