All

Thanks for all the help. Parts finally arrived and installed. Went to fire, was quite hard to kick over. Immediately figured issue with hoe I installed decompression. Had a peak. It wasn't moving. Backed off keeper bolt, then moved freely. But if I Tighten at all, it won't. Any tips or correct installation instructions? How much do you wind up...

Much appreciated. This one looks similar and fine. I think it was just the lack of oil broke the cam holder. Took it all apart and everything else looks fine luckily

Thanks. Once all together, I have an oil question I see it suggests 10w30 or 10w40 4 stroke oils I have some Lucas oil 10w40 for my street bike. I'm assuming I ca use this with no concerns? I know on my street bike I'm picky with shifting and I can notice different oils

I own him this summer by the looks of it haha. Can clean my race car and cut the grass lol

Could be, but would that be included, as the head sits below the cam holder and seems separate. Any options seem better

I will check that, bought th oil and filter today actually. For the cam, holder and bearings my dealers wants almost $600 CAD. Anyone have any suggestions? I'd prefer it all assembled (cam, holder, bearings). I saw that lastnight on ebay or something but cannot seem to find now. Your help sourcing is appreciated

Where is this bolt. To me, looking at rhe head etc, the only way I see oil getting up there is slinging off the chain almost like a chaincase.

This is why I reached out. Thanks! Figured was all one piece. Off to the dealer tomorrow, hope I don't go broke haha

Thank you. Didn't know was pressed in. Figured all one piece, that is what made no sense to me, I was like the marks all line up, how cpuld it be off, not like it could be twisted. I'd love to buy a cam and holder all together then. Piston and head seem ok! Other than some carbon on the...

Thanks, valves and piston look good luckily. I don't think I got the full story from my nephew. So new cam and holder? The lines all line up at TDC etc. Yes the ca looks as it got hot, but I don't see worn lobes etc, so what would it even change? Thanks