Posts
31
Joined
8/14/2023
Location
Pittsfield, NH, USA
I was getting ready to head to the track today and started the bike just to make sure she was fine. Fired up runs fine. But I noticed that coolant is coming from the over flow tube. So I took off the rad cap and started again. Lots of fluid movement and when I blip the thrills it shoots out. This is my first 4 stroke. I am also getting a small drop of coolant near the base of the cylinder and not sure if coming from head or base. Shouldn’t the coolant stay still with bike running and cap off? Any help would be greatly appreciated. I chose to stay home to avoid risking damage.
You can not start a 4 stroke and run it sitting still for long (1 minute) or it starts overheating and pushing coolant past the radiator cap and out the overflow tube.
What you are stating is pretty much normal.
With the return tube to the rad very close to the cap, you will get some fluid movement at the top when you take the cap off.
Does the exhaust smell like coolant? I just went through a bad head gasket on my 2024 YZ250F where it was leaking, but only slightly and did not smoke.
No runnnng fine so are you saying that it should spit cooling out with the top off when I hit the throttle. Exhaust smells fine. Oil is normal color.
I will grab a video and post.
The Shop
DeCal Works Huge Plastic Inventory of UFO and Polisport kits.
Luxon 4-Post Bar Mounts
$189.95 - $239.95
Yes, the water pump is mechanically tied to the crankshaft, the faster it spins, the faster the water pump spins.
Take it for a few minutes around the block and see if it's losing any coolant.
Ditch the OEM cap...try a 1.8
Do this, use a Mylers cap not a chinese POS. But, this isnt causing your problem. Dont run a four stroke more than a minute on the stand, they get hot fast and need as much airflow as possible. Coolant movement with the cap off is 100% normal, thats why you have a water pumper. Higher engine RPM = higher water pump speed = more flow/movement.
Post a reply to: 22 yz250f