2023 kx250f hard start cold?

weland28
Posts
53
Joined
2/22/2017
Location
Eagle Grove, IA, USA

Rebuilt a 23’ kx250 that shredded the rod bearing, replaced the crank, crank bearings, crank seals, piston, cam chain, intake valves 

I’ve gotten it to start and and runs and rides normal. After warm it will fire right up, but barely even tries to fire if cold, the slightest shot of starting fluid will make it start up.

I’m wondering if it’s the fuel pump, it dumps fuel out of the line and also will create pressure but I’m kind of concerned the fuel will just leak out of the pump when the tank is off.. is that normal on these kawi’s? Also the pressure in the line will dissipate after just a couple seconds, is that normal as well? 

I’ve pulled the fuel injector and it has a consistent spray pattern and doesn’t look dirty but it seems like a really light spray, I’ve done a lot of work on Ktms and it’s considerably less fuel than a ktm injector would spray.. maybe that’s just kawi’s?

The bike has good spark, I’ve drained the gas and replaced with fresh 91 octane, the valves are in spec, the timing is correct, the air boots to throttle body are tight, I did a compression test and it ran up to a little over 100psi (no clue what it’s supposed to be, especially with the auto decompression activated), the tps sensor voltage was at .59 volts, I moved it to .65 volts thinking that might give it a little extra fuel but didn’t really notice a change in anything. 
 

any sort of advice would be greatly appreciated im pretty lost and pretty well over Kawasaki’s 😂😅

|
weland28
Posts
53
Joined
2/22/2017
Location
Eagle Grove, IA, USA
7/17/2023 7:58am

Update: it was the fuel pump.. it is in fact not supposed to be doing the things I talked about above, after tearing it apart there was a torn o-ring on the output side of the pump in the tank, causing it to lose the pressure 

4

Post a reply to: 2023 kx250f hard start cold?

The Latest