Solved: Fork Rebuild: Rebound Adjuster not hitting spec

Day30
Posts
38
Joined
4/16/2021
Location
Mesa, AZ, USA
Edited Date/Time 6/6/2021 1:53pm
So I tightened the rebound adjuster onto the cartridge, removed the holding tool, and tightened the whole cartridge into the fork lug. Then realized I forgot the skinny rebound rod, put that in, and now the rebound adjuster tightens all the way onto the rebound rod without presenting a 1.5mm gap.

Does that mean I need a new rebound adjuster? Or what’s going on here since the gap isn’t present before torqueing.





|
Factor E
Posts
988
Joined
9/22/2011
Location
So Cal, CA, USA
6/5/2021 8:43pm
Put back together and count clicks
If different than normal pull apart and check rod
1
6/5/2021 10:11pm
Isn’t that nut threaded onto the rod? I’m not familiar with those forks, but I would guess you could loosen the rebound adjuster then thread the nut on another 1.5mm and tighten it up and measure the gap
1
Day30
Posts
38
Joined
4/16/2021
Location
Mesa, AZ, USA
6/6/2021 1:37am
Isn’t that nut threaded onto the rod? I’m not familiar with those forks, but I would guess you could loosen the rebound adjuster then thread the...
Isn’t that nut threaded onto the rod? I’m not familiar with those forks, but I would guess you could loosen the rebound adjuster then thread the nut on another 1.5mm and tighten it up and measure the gap
Yep that was the case, just needed to take the inner cartridge back out and thread the lock nut a bit farther. Easy fix. Thanks for the help!
6/6/2021 7:09am
Isn’t that nut threaded onto the rod? I’m not familiar with those forks, but I would guess you could loosen the rebound adjuster then thread the...
Isn’t that nut threaded onto the rod? I’m not familiar with those forks, but I would guess you could loosen the rebound adjuster then thread the nut on another 1.5mm and tighten it up and measure the gap
Day30 wrote:
Yep that was the case, just needed to take the inner cartridge back out and thread the lock nut a bit farther. Easy fix. Thanks for...
Yep that was the case, just needed to take the inner cartridge back out and thread the lock nut a bit farther. Easy fix. Thanks for the help!
Oh good. What forks are they? Showa?

The Shop

Day30
Posts
38
Joined
4/16/2021
Location
Mesa, AZ, USA
6/6/2021 1:50pm
Oh good. What forks are they? Showa?
These are KYB 48mm from Technical Touch, and I was following their service manual as well, the instructions are real surface level though
6/6/2021 1:53pm
Oh good. What forks are they? Showa?
Day30 wrote:
These are KYB 48mm from Technical Touch, and I was following their service manual as well, the instructions are real surface level though
Oh ok. I’ve worked on a few kyb sets and usually the manual just says to bottom the lock nut and rebound adjuster out, then tighten the lock nut. That’s the only reason I was curious. Thank you

Post a reply to: Solved: Fork Rebuild: Rebound Adjuster not hitting spec

The Latest