Posts
3
Joined
5/29/2019
Location
Frisco, TX
US
So I’m looking to buy the time Sert Kit to repair the stripped out hole where the gear oil drain bolt goes. On the right/clutch side of the engine case.
I looked at the manual and it says it’s an “m12”
When I go to order the Time Sert, which soze would I need to purchase for it to be the exact fit?
“M12 x 1.5”?
I just need to fix that issue regardless of whichever method I may need to use whether I go with a Time Sert, replacing the part that contains the threaded hole, or JB Weld the thing shut?? I’d consider JB Weld only if there is another drain hole on the opposite side.
Any help would be appreciated.
Thanks,
E.
I looked at the manual and it says it’s an “m12”
When I go to order the Time Sert, which soze would I need to purchase for it to be the exact fit?
“M12 x 1.5”?
I just need to fix that issue regardless of whichever method I may need to use whether I go with a Time Sert, replacing the part that contains the threaded hole, or JB Weld the thing shut?? I’d consider JB Weld only if there is another drain hole on the opposite side.
Any help would be appreciated.
Thanks,
E.
Post a reply to: Time Sert for 2015 Ktm 125 sx - Question/help