Mako 360 fat bar pad

yamahaha131
Profile picture for user yamahaha131
Posts
730
Joined
4/7/2010
Location
Newark, OH, USA
yamahaha131

Do these exist for a fat bar application. Tried trimming down an old pro taper pad and while I'm close, just doesn't work. 

|
Marty1028
Profile picture for user Marty1028
Posts
952
Joined
10/5/2017
Location
Lafayette, IN, USA
Marty1028 3/22/2024 8:01pm
3/22/2024 8:01pm
yamahaha131 wrote:

Do these exist for a fat bar application. Tried trimming down an old pro taper pad and while I'm close, just doesn't work. 

Nothing really works for these mounts. Ive seen guys that are running their KTMS stock rubber foam pad cover without the foam just so something is there. I just run mine with no pad. Billet looks pretty lol. 

1
yamahaha131
Profile picture for user yamahaha131
Posts
730
Joined
4/7/2010
Location
Newark, OH, USA
yamahaha131 3/23/2024 8:19am
3/23/2024 8:19am

IMG 9590 0.jpeg?VersionId=TliBuJ
 

Ended up butchering my pad and cover to make it work. Billet is pretty but just kept imagining my chin bouncing off of it

FilthyGrungy 3/23/2024 9:01am
3/23/2024 9:01am

IMG 0197I moved my Mako over to a new bike and since it was so beat to hell, I sat down with the PT crossbar pad and Mako in hand (that was key) and I started trimming away with a razor blade but soon realized I needed to trim for height inside the pad. I took a Milwaukee multi tool and was able to cut through the pad like butter for vertical clearance. If doing again, I would have just used the multi tool from the get go. Would have been a PITA in the mako was mounted on the bike at the time of trimming but after doing it once I’m sure I could make it work

1

Post a reply to: Mako 360 fat bar pad