Carbon fiber pipe hangers upper and lower, case savers

Arln.rm125 wrote:

Hey all, posting about more parts I make to see if there's any interest in them, I've been experimenting with carbon and titanium lower pipe hangers...

Hey all,

posting about more parts I make to see if there's any interest in them, I've been experimenting with carbon and titanium lower pipe hangers and have had good success in strength testing. They haven't had much in field testing yet. But I'm quite confident they will hold up off the stress testing results. I've found they take significantly more stress than the stock ones before failing. And when they do fail its from the rubber itself ripping. This testing was done with impact stresses. I've stress tested both KX and RM lower hangers now. And seen the same failures from both. The stock one fails from the aluminum yielding. below I will attach photos, The hangers I'll post photos of are a bit messy as they were prototype parts.

I also sell matching upper carbon pipe hangers. The upper hangers fit YZ, CR, RM. And are 35 usd plus shipping, drilled aluminum washers included.

lower 01+ rm125/250 are available, 65 usd.

upper and lower 03+ kx125/250 are available, 65 usd for upper or lower. 120 usd for both.

currently working on YZ and CR lower hangers, price yet to be determined

Also have 01+ rm125 carbon case savers in stock. 35 usd plus shipping

I can make custom parts on requestBelow is the carbon one I tested, the failure point is the rubber itself splitting. I found this same result from 2 destructive tests

below is how the stock ones fail