Posts
7
Joined
10/22/2018
Location
SE
Edited Date/Time
8/19/2020 2:28am
Hi!
Just got myself a cartridge kit from öhlins to my ktm sx 250 2019, the install was pretty straight forward. But got a question about preload settings, the manual says 8-11mm preload is recomended.
It came with a bunch of plastic spacers in different sidens to adjust preload settings. The total spring installation should be 491mm, the spring itself is only 465mm.
Should i put spacers so i get the correct spring installation measurement and then add more spacers to get the preload correct?
Do i get a negative preload if i dont have enough spacers to get the recommended spring length?
The spring sits tight without any spacers.
Just got myself a cartridge kit from öhlins to my ktm sx 250 2019, the install was pretty straight forward. But got a question about preload settings, the manual says 8-11mm preload is recomended.
It came with a bunch of plastic spacers in different sidens to adjust preload settings. The total spring installation should be 491mm, the spring itself is only 465mm.
Should i put spacers so i get the correct spring installation measurement and then add more spacers to get the preload correct?
Do i get a negative preload if i dont have enough spacers to get the recommended spring length?
The spring sits tight without any spacers.
https://www.ohlins.com/app/uploads/world/2017/08/MI_FGKT1893-94_1.pdf
The Shop
DeCal Works Huge Plastic Inventory of UFO and Polisport kits.
Luxon 4-Post Bar Mounts
$189.95 - $239.95
Post a reply to: Öhlins cartridge AER fork