Trying my hand at moto edits

NOXiiClothing
Edited Date/Time 1/24/2012 8:30pm
I shot this last weekend in Sterling, Colorado at Pawnee Cycle Club. Any feedback would be appreciated!
Thanks for watching.

If the embed code didn't work you can watch it here
My vimeo page

|
whyderp168
Profile picture for user whyderp168
Posts
30
Joined
5/31/2010
Location
N/A, CA, USA
whyderp168 5/17/2011 7:07pm
5/17/2011 7:07pm
What kind of rig did you use in the beginning for the panning?
NOXiiClothing 7/10/2011 7:14am
7/10/2011 7:14am
I used the Igus Slider. It's the cheapest most durable slider you can get under $1000 I think. It's built for a CNC machine but works perfect for slider shots and it's only $160.
dak
Profile picture for user dak
Posts
45
Joined
7/20/2011
Location
Westland, MI, USA
dak 7/23/2011 11:40am
7/23/2011 11:40am
NOXiiClothing wrote:
I used the Igus Slider. It's the cheapest most durable slider you can get under $1000 I think. It's built for a CNC machine but works...
I used the Igus Slider. It's the cheapest most durable slider you can get under $1000 I think. It's built for a CNC machine but works perfect for slider shots and it's only $160.
good vid but most of the shots of the riders were shakey. everything else was perfect though
NOXiiClothing 7/23/2011 12:03pm
7/23/2011 12:03pm
Thanks Dak...Yeah the shakyness of it all gets pretty annoying and almost requires dramamine to watch. I have recently switch to shooting mostly with a tripod and have purchased a better camera with a higher frame rate that helps with the handheld shake.

Post a reply to: Trying my hand at moto edits