Yz250 clutch.

Nootnam
Profile picture for user Nootnam
Posts
12
Joined
3/20/2018
Location
Wildomar, CA US
Nootnam
Im currently building an o1 yz250. I'm running into an issue with the clutch where the push rod has about a half inch of movement before it even makes contact with the pressure plate. So the push lever is really only doing about half the job it's supposed to. Can anybody give some insight?
|
Paw Paw 271
Profile picture for user Paw Paw 271
Posts
3640
Joined
4/3/2013
Location
Benton, LA US
Paw Paw 271 6/29/2018 9:57pm
6/29/2018 9:57pm Edited Date/Time 6/29/2018 9:58pm
Make sure clutch hub and basket are fully seated.
Make sure you have the correct number of plates installed.
Are you sure you have all the parts back in place correctly. Look at a parts drawing to be sure.
Adjust the cable.

Paw Paw
Nootnam
Profile picture for user Nootnam
Posts
12
Joined
3/20/2018
Location
Wildomar, CA US
Nootnam 6/30/2018 6:00am
6/30/2018 6:00am
Paw Paw 271 wrote:
Make sure clutch hub and basket are fully seated. Make sure you have the correct number of plates installed. Are you sure you have all the...
Make sure clutch hub and basket are fully seated.
Make sure you have the correct number of plates installed.
Are you sure you have all the parts back in place correctly. Look at a parts drawing to be sure.
Adjust the cable.

Paw Paw
Yea, I'm positive everything is seated properly and it's the right amount of plates. I'll take it apart again today just to be 100% cause idk what else it could be.

Post a reply to: Yz250 clutch.