WP Cone Valve Holeshot Device Ring

Jterry
Profile picture for user Jterry
Posts
235
Joined
11/11/2015
Location
Cottondale, AL US
Jterry
Has anyone ran WP Cone Valve forks on a 14+ YZF and used a Works Connection holeshot device?

I have the holeshot device that fits on the stock KYB forks. But it wont go onto the WP stuff. Just looking to see if anyone would know the part # for the fork ring I would need?
|
mx317
Profile picture for user mx317
Posts
4561
Joined
4/1/2008
Location
TN US
mx317 6/12/2018 2:07pm
6/12/2018 2:07pm
Measure and call WC. I am actually using a Kawasaki ring on my KTM cone valves, but I'm not sure it's the same OD as yours. It was probably a mm smaller, but it spread apart slightly and the screw went right in.
Jterry
Profile picture for user Jterry
Posts
235
Joined
11/11/2015
Location
Cottondale, AL US
Jterry 6/12/2018 4:58pm
6/12/2018 4:58pm
I've measured and sent them to WC just waiting on an email back. I was just hoping someone on here had done it before. Any chance you could measure yours? And what was the ring originally intended to fit? A KX450? What year?

Thanks
mx317
Profile picture for user mx317
Posts
4561
Joined
4/1/2008
Location
TN US
mx317 6/12/2018 6:44pm
6/12/2018 6:44pm
Mine measures 58mm right above the screw on seal holder. My ring is from a KXF450, but not sure of year. I seem to remember moving it from my 11 to my 15 and it worked.
mx317
Profile picture for user mx317
Posts
4561
Joined
4/1/2008
Location
TN US
mx317 6/12/2018 6:49pm
6/12/2018 6:49pm
There is a different part number between the 11 and 15, but I think the only difference is the template to mount the device because the fork guards are different.

The Shop

See All »
Jterry
Profile picture for user Jterry
Posts
235
Joined
11/11/2015
Location
Cottondale, AL US
Jterry 6/12/2018 7:27pm
6/12/2018 7:27pm
Thanks the cone valve forks measure the 58mm. I'll call and get that ring.
mx317
Profile picture for user mx317
Posts
4561
Joined
4/1/2008
Location
TN US
mx317 6/13/2018 3:31am
6/13/2018 3:31am
They may have a 58mm one to fit exact. The Kawasaki one did work fine after I opened it up slightly. It wasn't so much the screw didn't thread right in though. I had it laying around and it saved me a few bucks. I already had the kit for the stock WP AER forks, but the fork tube OD is different.
Jterry
Profile picture for user Jterry
Posts
235
Joined
11/11/2015
Location
Cottondale, AL US
Jterry 6/13/2018 1:19pm
6/13/2018 1:19pm
Yeah I called today and they have one that is made for the cone valve stuff. So I got it.

Post a reply to: WP Cone Valve Holeshot Device Ring