Trans. Bearing replacement

Related:
Create New Tag

11/18/2017 6:12 PM

I am building a 2003 cr125. One trans bearing has a black oil seal built to it. I do not remember seeing it before the bearings were removed. The shop manual does not mention it at all. Does anyone know which way the bearing goes? Does it matter? I have always installed bearings with the writing up which would put the seal down against the case. It is the bearing for the shaft that drives the clutch basket.

|

11/18/2017 6:34 PM

I would say you would want the open side of the bearing inwards towards the oil,

|

11/19/2017 10:00 AM

beamer wrote:

I would say you would want the open side of the bearing inwards towards the oil,

X2

|

Many thanks to everyone helping me out this GNCC season: SRT Offroad, Acerbis, FCR Suspension, O'Neal Racing, Evans Waterless Coolants, Rekluse, Twin Air, Braking Brakes, Carbsport

Profile image credit Ken Hill Photography

11/19/2017 1:37 PM

Just pull the seal off

|