Posts: 50
Joined: 4/1/2018
Location: GBR
Happy Easter everyone!
I have managed to get a set of Technical Touch KYB a kit forks and shock for the right price. Only problem is they are from an RMZ 250 and I want to put them on my KXF250. Does anyone know if these will fit or what mods are needed?
If I can’t make them fit, then they will be up for sale
Posts: 9017
Joined: 1/4/2014
Location: FIN
Edited Date/Time:
I have no idea if they'll fit. I'm sure someone knows and you'll get an answer.
The thing i can contribute to is that you can get KXF lugs(from Technical Touch) for the forks and then they should fit if they fit the clamps on your KXF.
Posts: 924
Joined: 9/7/2012
Location: MA, USA
You’d have to know what the center to center spacing it on either set of clamps. Easiest thing may be to run a Suzuki front wheel and caliper set up, assuming the clamps are the same spacing wise.
If you're not mixing gas, you're not haulin ass.
Posts: 5509
Joined: 1/31/2018
Location: Mansfield, OH USA
What year bikes are we talking? For a while kawasaki was actually making the rmz250. Even later years they were very similar bikes
Posts: 392
Joined: 7/19/2016
Location: Roseville, CA USA
Posts: 50
Joined: 4/1/2018
Location: GBR
Thanks for the replies folks, much appreciated!
The KXF is a 2018 and the suspension is off a 2017 RMZ250. 400 Euro for the lugs isn’t too bad but I want to see if they can be made to fit any other way first.
As far as I can see if I use my clamps and get them machined if necessary to fit these forks, surely it must just be down to the wheel spacers to get them to fit?
