Posts
2963
Joined
10/14/2017
Location
86oh, CT
US
Going to be installing a factory connection Link. Its 2mm longer then stock. Should end up lowering the rear end just a bit. I pushed the forks up 5mm up in the clamps. I usually run around 106mm of sag. Any clue what I should set my sag to after I install the link? Should I lighten up the compression a few clicks since the initial stroke will be stiffer? Trying to get a solid baseline before I go and ride. Suspension is all stock. 190lb vet rider.
The best way is to do a moto stock then swap out the link, reset sag.
Maybe with the link you can run a higher sag number around 100-102 where i've typically ran Yamaha's.
The Shop
Where in CT do you ride? Sucks that rocky hill is gone
Post a reply to: Sag setting for 2017 yz450f with aftermarker suspension link