Posts: 207
Joined: 9/7/2017
Location: CAN
I bought a used rs4 system and was going to replace the insert because it's stupid loud right now , anyways the insert screw is stripped ,was wondering if anyone else had this issue ,the screw will turn about a quarter turn and then it's just stuck , I tried heat and everything else and now the screw head is stripped out as well ,looking for some advice as how to get this screw out now
Posts: 6706
Joined: 11/30/2013
Location: Portland/Los Angeles, CA USA
Maybe send it back to Yosh for a refurb service. It might be really loud because the packing is worn out.
Posts: 207
Joined: 9/7/2017
Location: CAN
CarlinoJoeVideo wrote:
Maybe send it back to Yosh for a refurb service. It might be really loud because the packing is worn out.
No I repacked it as soon as I got it , there's no insert actually in there right now ,just the screw and I need to get it out to I can put in the insert
Posts: 6706
Joined: 11/30/2013
Location: Portland/Los Angeles, CA USA
You try vice grips? Not sure how high it’s sticking out.
Maybe cut a line in it with the dremel tool then bend a flat blade screw driver 90 degrees so it will fit in the slot?
