Posts
578
Joined
3/5/2017
Location
TN
US
My rm125 had 1 1/8 bars and bar mounts on it when i purchased it and I wanted to switch over to the 7/8, I reached out to a fellow rm owner who told me I could just run CR125/250 bar mounts. I bought a set of cr bar mounts and when I went to install them I found that the studs wouldn’t fit down into my current rubber dampers so I drilled them out to fit, after doing that and tightening them down my bars (mounts and all) will still kinda move around. Do I need to buy the cr rubber mounts or just go a completely different route?
My suggestion is to bite the bullet and get the right bar mounts for your triple clamp.
The Shop
Post a reply to: Rm125 bar mount situation