Posts: 464
Joined: 1/30/2014
Location: Lodi, CA USA
Looking for the torque specifications. I recently purchased a brand new set of upper and lower clamps for my 06 RM250.
Upper clamp tube pinch bolts?
Lower clamp pinch bolts
Handle Bar pinch bolts
Dampener bolts that hold the bar mounts
Thanks....... If any one has documentation that would be great.
Posts: 20107
Joined: 6/15/2010
Location: Bowie, MD USA
Posts: 464
Joined: 1/30/2014
Location: Lodi, CA USA
Posts: 505
Joined: 7/19/2016
Location: Reno, NV USA
Posts: 449
Joined: 12/12/2016
Location: CO, USA
It's the same torque value as what is in your service manual. I've had an 06 RM250 for ten years with RG3 clamps
Posts: 36
Joined: 7/24/2017
Location: CAN
I tighten the bar mounts tight so they cant move, The upper pinch bolts I do 17ft pds and 16 on the bottom. hope this helps
Posts: 464
Joined: 1/30/2014
Location: Lodi, CA USA
Posts: 1729
Joined: 8/25/2015
Location: Mansfield, OH USA
Call rg3. If the part that holds the fork is thicker/thinner it will require a different spec. Bending 1/8” aluminum at 10ft lbs is easier than bending 1/4” alumimum at 10ft lbs.
2009 Kawasaki KX450F
2009 Kawasaki KX250F
2002 Suzuki GSXR 600
Posts: 464
Joined: 1/30/2014
Location: Lodi, CA USA
Acidreamer wrote:Call rg3. If the part that holds the fork is thicker/thinner it will require a different spec. Bending 1/8” aluminum at 10ft ...more
After several days of trying to get in touch with RG3.... I spoke to a real person. RG3 is having phone issues, which explains why no answer, v/m or anything. Got all the torque spec's I was looking for.
Thanks
Posts: 635
Joined: 12/29/2012
Location: WI, USA
RG3 is still in business and still offering new clamp sets for 2006 RM250's? Wow. I emailed with no response and also tried calling with no response 2 weeks ago. Would have preferred the RG3 clamps but had to go with Applied instead.
Posts: 464
Joined: 1/30/2014
Location: Lodi, CA USA
These were NOS from several years back. My suspension tuner mentioned to me that he had a brand new set for a RM250 for the Showa forks asked if I wanted them?? Verified the part # for the upper and lowers... good to go! Pressed in a new stem and bearing set and were good!
